JBLV200TWS Bluetooth Earbuds User Guide
- June 6, 2024
- JBL
Table of Contents
JBLV200TWS Bluetooth Earbuds User Guide
WHAT’S IN THE BOX
How to wear
-
Try different sizes of eartips for best fit and seal.
-
FIRST TIME USE
Power on & Connect
DUAL CONNECT
BUTTON COMMAND
-
Stereo Mode
-
Mono Mode
Seamless automatic switch
Power off
Manual Controls
Connect to a new Bluetooth device
RECONNECT LEFT & RIGHT
Factory reset
Charging
Led behaviors
TECH SPEC
- Model: VIBE200TWS
- Driver size: 8 mm/ 0.315” Dynamic Driver
- Power supply: 5 V 1 A
- Weight: 47.5 g/ 0.105 lbs
- Headset battery type: Lithium-ion Battery (48 mAh/ 3.7 V)
- Charging case battery type: Lithium-ion Battery(500 mAh/ 3.7 V)
- Charging time: 2 hrs from empty
- Music playtime with BT on: up to 5 hrs
- Frequency response: 20 Hz – 20 kHz
- Impedance: 16 ohm
- Sensitivity: 108dB SPL@1 kHz
- Maximum SPL: 93 dB
- Microphone sensitivity: -38 dBV/Pa @1 kHz
- Bluetooth version: 5.0
- Bluetooth profile version: A2DP V1.3, AVRCP V1.6, HFP V1.7
- Bluetooth transmitter frequency range: 2.400 GHz – 2.4835 GHz
- Bluetooth transmitter power: 12 dBm
- Bluetooth transmitter modulation: GFSK, π/4 QPSK, 8DPSK
- Maximum operation temperature: 45°C
IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaged over one gram of tissue.
Device types: (IC: 6132A-JBLV200TWS) has also been tested against this SAR
limit According to this standard, the highest SAR value reported during
product certification for head use is 0.205W/Kg.The device was tested for
typical bodily operations where the product was kept 0 mm from the head. To
maintain compliance with IC RF exposure requirements, use accessories that
maintain a separation distance of 0mm between the user›s head and the back of
the headset. The use of belt clips, holsters and similar accessories shall not
contain metal parts in its assembly. Use of accessories that do not meet these
requirements may not comply with IC RF exposure requirements and should be
avoided.
Head operation
The device was subjected to a typical head manipulation test. In order to
comply with RF exposure requirements, a minimum separation distance of 0 cm
must be maintained between the user›s ear and the product (including the
antenna). Head exposure that do not meet these requirements may not meet RF
exposure requirements and should be avoided. Use only the supplied or approved
antenna. IC: 6132A-JBLV200TWS
FCC ID: APIJBLV200TWS
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by HARMAN International
Industries, Incorporated is under license. Other trademarks and trade names
are those of their respective owners
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>