GROHE DN 15 CC150 Shower Mixer Instruction Manual

GROHE DN 15 CC150 Shower Mixer

Instruction

Safety notes

Protection against scalding

It is recommended that near points of discharge with particular sensitivity to the outlet temperature
(hospitals, schools, nursing and retirement homes) thermostatic devices should be installed which can limit the water temperature to 43 °C. The product includes an appropriate temperature end stop. It is generally recommended that the temperature of shower-systems should not exceed 38 °C in nurseries and specific areas of care centers. Use Geotherm Special thermostats with special handle to facilitate thermal disinfection and appropriate safety end stop. Applicable standards (e. g. EN 806-2) and technical regulations for drinking water must be observed.

Application

Thermostat mixers are designed for hot water supply via pressurized storage heaters and, utilized in this way, provide the best temperature accuracy. With sufficient power output (from 18 kW or 250 kcal/min), electric or gas instantaneous heaters are also suitable.
Thermostats cannot be used in conjunction with non-pressurized storage heaters (displacement water heaters).
All thermostats are adjusted in the factory at a flow pressure of 3 bar on both sides.
Should temperature deviations occur on account of special installation conditions, the thermostat must be adapted to local conditions (see Adjusting).

Specifications

Safety stop
Hot water temperature at supply connection min. 2 °C higher than mixed water temperature
Thermal disinfection possible

Minimum flow rate
If static pressure exceeds 5 bar, a pressure reducing valve must be fitted.

Installation
The projection can be increased by 20mm with an extension, see Replacement Parts, Prod. no. 07 130.

Installation of the shower rail
When installing e.g. on plasterboard walls (not solid walls) it must be assured that an appropriate reinforcement is in place to ensure sufficient strength.

Adjusting
Temperature adjustment.

Temperature end stop
If the temperature end stop is at 43 °C, insert accompanying temperature limiter in temperature selection handle.

Operation
The safety stop limits the temperature range to 38 °C. The 38 °C limit can be overridden by pressing the button, see page 3.

Prevention of frost damage
When the domestic water system is drained, thermostat mixers must be drained separately, since non-return valves are installed in the hot and cold water connections. For this purpose, the mixer must be removed from the wall.

Maintenance
Inspect and clean all parts, replace if necessary and lubricate with special valve grease.
Shut off the hot and cold water supply.

Non-return valve
Drain the fitting before disassembling.
Thermostatic compact cartridge, see page 4. Readjustment is necessary after every maintenance operation on the thermostatic compact cartridge
(see Adjusting).

S howers
The function of the SpeedClean nozzles is guaranteed for a period of five years.
Thanks to the SpeedClean nozzles, which must be regularly cleaned, limescale deposits on the rose can be removed by simply rubbing with the fingers.

Replacement parts
( * = special accessories).

Care
For directions on care, refer to the accompanying Care Instructions.

References

• Welcome | GROHE
• GROHE: Alles voor je badkamer, keuken en toilet | GROHE België nv
• Alles voor je Badkamer, Keuken en Toilet | GROHE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>