home zone IWH2301LL 4PK Outdoor Low Voltage LED Spot Light Instruction Manual
- June 6, 2024
- home zone
Table of Contents
home zone IWH2301LL 4PK Outdoor Low Voltage LED Spot Light Instruction Manual
PLEASE READ CAREFULLY AND SAVE THESE INSTRUCTIONS, AS YOU MAY NEED THEM AT A LATER DATE
IMPORTANT SAFETY OPERATING INSTRUCTIONS
- Please read all warning and instruction labels which are included in the box and fixture to avoid personal injury, property damage caused by fire, cuts, bruises, death and other dangers.
- Please follow these general precautions before installing, maintaining, or fixing.
WARNING
- The packing contains small parts that could be swallowed by children.
- Keep the packaging material away from children and pets.
- The spot light is not a toy.
- We do not take responsibility if the instruction manual is not followed correctly or if the product is handled improperly resulting in damage to person or property.
REF. PARTS
PARAMETERS:
- Dimension: 7 inch x 3 inch x 11.8 inch
- Light Source: 7.5W LED
- Brightness: 41 O lumen
- Color Temperature: 3000K
HOW TO OPERATE AND INSTALL
Figure 1 Attaching and installing the light
WARNING: Never use a hammer to insert the stake into the ground.
- Insert the fixture wire of the wire connector (C} into the groove located on the top of the ground stake (B}.
- Prepare a hole in the installation location. Use a tool (not included) to dig an installation hole (the hole should not be larger than the stake (B)).
- Install the fixture in the ground.
Figure 2 Connecting the wires
- Open the wire connector
- Align and fit the low voltage power cord (not included) from transformer (not included} to the slot of the wire connector
- Press the wire connector until it is locked.
- Once the wire connector is in place, it is recommended to wrap whole wire connector with electrical tape (not included) to avoid any water exposure during use.
- After all fixtures are installed, turn on the transformer (not included).
WARNING: The wire connector (C) contacts have sharp edges for piercing the main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16 AWG type underground low Energy Circuit Cable.
CLEANING AND MAINTENANCE
- Clean the fixture with a soft dry cloth.
- Do not use any cleaners with chemicals, solvents or harsh abrasives.
TROUBLESHOOTING
CABLE SELECTION
WARNING: This product can expose you to chemicals including lead and lead compounds, Di (2-ethylhexyl) phthalate (DEHP), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
WARNING – Risk of Electric Shock. Install power unit 5 feet (1.5 m) or more from a pool, spa. or fountain. Where the power unit is installed (a) indoors within 10 feet (3.0 m) of a pool, spa, or fountain or (b) outdoors, connect power unit to a receptacle protected by a GFCI. Main low voltage cable is intended for shallow burial – less than 6 inches (152 mm).
Low voltage cable must:
a) be protected by routing in close proximity to the luminaire or fitting, or
next to a building structure such as a house or deck;
b) not be buried except for a maximum 6 inches (15.2 cm) in order to connect
to the main low voltage cable.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Warning: Changes or
modification to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limited for Class B digital device, pursuant to Part 15 of the FCC Rules. Their limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and the receiver.
■ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
Only for use with low voltage landscape lighting power units with a maximum output rating of 12 Volts, 300 Watts .
Why Register?
- Receive your extended warranty
- Get professional warranty support
- Be the first to hear the latest product news.
- Get exclusive deals delivered to you email.
http://homezonesecurity.com/warranty
homezonesecurity.com
support@homezone-usa.com
US: +1 888-782-5618
Get exclusive offers and deals when you subscribe!
Thank you for choosing Home Zone Security!
We are here to support you every step of the way.
Please be sure to contact our customer support for troubleshooting and register your product for additional benefits. Products must be sold by an authorized reseller or distributor to be valid.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>