Home zone security ELI0991V Solar Down Light Motion Sensor Installation Guide

Home zone security ELI0991V Solar Down Light Motion Sensor Installation

Guide

Solar Down Wall Light

Model No. ELI0991V
IMPORTANT SAFETY OPERATING INSTRUCTIONS
1. Please read all warning and instruction labels which are included in the box and fixture to avoid personal injury, property damage caused by fire, cuts, bruises, death and other dangers.
2. Please follow these general precautions before installing, maintaining, or fixing

WARNING

1. The packing contains small parts that could be swallowed by children
2. Keep the packaging material away from children and pets
3. The solar light is not a toy
4. We do not take responsibility if the instruction manual is not followed correctly or if the product is handled improperly resulting in damage to person or property
   

PRECAUTION

1.  It is important to select an outdoor location with full, direct sunlight where the solar panel can receive at least 8 hours of sunlight each day.
2. It is important to avoid placing the solar light by light sources, such as street lights or porch lights, which may cause the solar light to turn off automatically.
3. To avoid explosion and corrosion, please keep the solar light away from from fire and humid environment
4. No striking to avoid any damages to solar cell

REF. PARTS

PARAMETER

1. Dimension: Approx. Dia 6.93″ (17.6 cm) x 2.44″ (6.2 cm)
2. Light source: 21 pcs white LEDs
3. Brightness: 30 lumens for standby; 200 lumens for motion sensor activated
   

HOW TO OPERATE AND INSTALL
Figure 1:
• Push the switch to “ON” position
Figure 2:
• Choose desired wall location. Drill two holes on the wall. Insert the plastic anchors and screw the screws into the wall, leaving about 2mm long thread.
• Hang the light on the screws with the mounting holes.
• Make sure the location where it can receive a full 8 hours of sunlight to
allow the rechargeable battery to reach maximum capacity.
Note: Lights with solar panels may have a protective film over the solar panel. This must be removed prior to use.

HOW IT WORKS

CLEANING AND MAINTENANCE

1. Use a damp cloth to clean the solar panel
2. To avoid any damage to this light, please do not use any chemical or abrasive cleaner

RECHARGEABLE BATTERY
This product contains (1) 3.7V 18650 1800mAH Li-ion rechargeable battery. When the battery expires, it must be recycled or disposed of properly. Please contact your local waste disposal authority for correct procedure. Do not put battery into fire.

Battery Replacement

• Use a screwdriver to remove the 4 screws on the back of the unit.
• Open the battery chamber cover.
• Replace the old battery with new battery making sure the polarity is correct.
• Place back the battery chamber cover by tightening the 4 screws.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>