Feuymoent LET614 Human Baby Sensing Light Strip User Manual
- June 12, 2024
- FEUYMOENT
Table of Contents
LET614 Human Baby Sensing Light Strip
User Manual
Human baby sensing light strip
- short press on cable to switch mode.
- long press on cable to power on/off.
FCC ID:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE
- During use, if the switch can work normally, but the remote control cannot, you need to perform the code matching operation.
- If the light is interfered by other remote controls or cannot be controlled remotely. Please power off and then power on again before performing code matching.
- After power on, the product is in automatic induction mode. Equipped with automatic sensing and time control functions. Automatically turn on lighting when someone is moving within the detection range; When a person leaves, the lighting will continue for 30 seconds before turning off.
How to perform code matching operation: Press and hold the power button on the
remoter for 3 seconds within 7 seconds of turning on the power, the light
strip flashes 3 times with white light, indicating that the code (remote
control) is matched.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interferenceto radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
ISED Warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the foll owing two conditions: (1)this device may not
cause interference, and(2) this device must accept any interference,
includinginterference that may cause undesired operation of the device.
NOTE: This equipment has been tested and found to c
The device has been evaluated to meet general RF exposure requirement. The
device can be used installed and operated with minimum distance 0mm between
the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>