home zone ES06577G Additional Sensor Instruction Manual
- June 6, 2024
- home zone
Table of Contents
home zone ES06577G Additional Sensor
Warning
PLEASE READ CAREFULLY AND SAVE THESE INSTRUCTIONS, AS YOU MAY NEED THEM AT A LATER DATE
IMPORTANT SAFETY OPERATING INSTRUCTIONS
- Please read all warning and instruction labels which are included in the box and fixture to avoid personal injury, property damage caused by fire, cuts, bruises, death and other dangers.
- Please follow these general precautions before installing, maintaining, or fixing.
WARNING
- The packing contains small parts that could be swallowed by children.
- Keep the packaging material away from children and pets.
- Do not look directly at the LED lights for any length of time.
- This light fixture is NOT A TOY and is not suitable for use by children.
- We do not take responsibility if the instruction manual is not followed correctly or if the product is handled improperly resulting in damage to person or property.
WARNING:
This product can expose you to chemicals including lead and lead compounds,
Di(2-ethylhexyl)phthalate (DEHP). which are known to the State of California
to cause cancer and birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov.
LOCATION
Fixture can be wall-mounted.
Recommended installation height: 4 – 8 feet above the ground. Environment will
affects the sensor range. It is recommended not to mount the fixture near a
heat source like an air conditioner, vent, or furnace exhaust, or in a
direction facing a light reflecting object.
Maybe the sensor detection distance will decrease lower than 16 feet in some
special environment.
What’s in the box
PREPARATION
Tools required for assembly (not included): phillips screwdriver, safety goggles, power drill and ladder.
- Sensor
- Mounting plate
- Mounting screw
- Anchor
Parameter
- Detection range: 16 feet x 110 degree
- Power source: 3 AAA batteries (not included)
- 4 channels selection
- Transmission distance: up to 164ft (50m)
How to installation and operation
-
Slide the mounting plate (part B) off the back of the sensor (part A).
-
Loose the screw (turning anticlockwise) and open the battery cover from the back of the sensor (part A).
-
Insert three 1.5V AAA size batteries (not included) and choose your desired channel (4 channels option, based on the selected channel of the product that you want to link) next to the inside of the battery chamber. Then close the battery cover and lock the screw tightly (clockwise).
Note: Make sure the polarity of the batteries is correct.
Cleaning and Maintenance
FCC STATMENT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>