anko DF-2021114FTL Low Voltage 4FT Nutcracker Inflatable Instruction Manual

Table of Contents

anko DF-2021114FTL Low Voltage 4FT Nutcracker Inflatable-
pro

These instructions are for your safety. Please read through them thoroughly before use and retain for future reference.

Before You Start

Decide on an appropriate location for your product (see Installation instructions below).
If you have any doubt about installing this product, consult a qualified electrician.

This inflatable product is suitable for INDOOR AND OUTDOOR USE.
The AC adaptor MUST be installed INDOORS away from weather.
Do not position or place near heaters or any other direct sources of heat.
This product is suitable for positioning on surfaces which have normal flammability, e.g. wood, plasterboard, masonry. However this does not include highly flammable surfaces (e.g. polystyrene, textiles).
Always position cables and extension leads so that they will not be a hazard to the elderly, pets and children.
DO NOT position this inflatable product where it may become covered by other items e.g. curtains, nets or bedding.
Ensure the unit is positioned so that you have enough cable to reach an indoor mains power socket

Warning

This inflatable product is suitable for INDOOR AND OUTDOOR USE.
This product is NOT designed for permanent or long term use.
The AC adaptor MUST be installed INDOORS away from weather.
The supplied adaptor is suitable for operation of LED Modules only.
Only operate this light set with the supplied adaptor, Model No. JT-DC12V9W-F3
Do not connect this inflatable product electrically to another inflatable product.
Do not connect this inflatable product to the power supply while it is in the packaging.
DO NOT attempt to replace the non-replaceable bulbs in this inflatable product.
Never allow any part of the set to come into contact with a source of heat or flame.
Care must be taken to avoid damage the cable or fittings.
If any part of light set or cable is damaged, the light set MUST be discarded.
This product is for use as a decoration only. Not to be used by children as a toy. Keep out of reach of children.
Do not position this inflatable product where it will be exposed to extreme wet weather or submerged in water.
Always switch off this light set or unplug an adaptor if unattended.
DO NOT overload power sockets or extension leads.
DO NOT pierce the cable when securing in place, bend or stand on the standing light, as this will damage the bulbs or wiring
Please refer to the packing or product rating label for product class, specifications and rating.

anko DF-2021114FTL Low Voltage 4FT Nutcracker
Inflatable-1 anko DF-2021114FTL
Low Voltage 4FT Nutcracker Inflatable-2

This inflatable product is constructed with non-replaceable bulbs. DO NOT attempt to replace any of the bulbs in the light set.
Keycode: 43069842

Do not open the cover of the equipments.
The power supply is suitable for LED modules.
The input and output voltage should be checked before use to ensure correct use.
This is the Class II product, JT-DC12V9W-F3 is only for indoor use.
The product is not a toy, keep it where children can not reach.
The lamp control gear does not rely upon the luminaire enclosure for protection against accidental contact with live parts.
The adaptor is for socket mounted only. Not for Recess Use.
The minimum clearance distance from the top and sides of the control gear to normally flammable building elements is 225 mm and 300 mm.
The minimum clearance distance from the top and sides of the control gear to normally flammable building elements.
If the minimum clearance distances from each side of the control gear are different, or there are different minimum clearance distances for various types of normally flammable building element or building insulation, then each minimum clearance distance shall be stated separately.
Where control gear is required to be mounted on a specific surface or has additional installation requirements, for example, use in non-combustible enclosed space or to ensure adequate sealing to maintain its IP rating, the relevant information shall be supplied with the control gear