Rosewill RBWC-20025 100W Power Adapter Instruction Manual

: June 6, 2024
: Rosewill

Table of Contents

INTRODUCTION
FEATURES
OPERATION
CONNECTION DIAGRAM
SPECIFICATIONS
PACKAGE CONTENTS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RBWC-20025
Thank you for purchasing a Rosewill Power Adapter.
Please read the instruction manual before use and retain for future reference.

INTRODUCTION

This product is a high-performance travel charger. It is equipped with four USB connectors which allow four devices to be charged at the same time. The unique design makes your life simpler and easier.

FEATURES

Input Voltage: 100-240VAC 50/60Hz 1.6A Max
Output Four Port USB-C1: 5V,9V,15V/3A, 20V/3.25A (65W) USB-C2: 5V/3A,9V/2A (18W) USB-Al + A2: 5V/3.4A Max(Totall 7W)
Output Single Port USB-C1: 5V/3A, 9V/3A, 15V/3A, 20V/5A (100VV) Total: 100W Max
Safety Protection: – Accurate limited current output and over current protection – Overload protection – Over voltage protection – Short circuit protection – Over temperature protection and auto-recovery to remove the fault condition.
Compliant with UL, FCC, and DOE standards.
Specially designed for your USB-C supported devices.

OPERATION

Operation Procedures

Pull down the DC connector of the power adapter and plug it into a powered outlet.
Plug one end of your USB cable into the power adapter and then plug the other end of your cable into your device.
Please unplug your USB cable after your device is fully charged.

Operation Notes

For optimum performance, please use the power adapter according to the user manual.
Please plug the power adapter into an outlet whose voltage range should be 100-240VAC.
Please unplug the power adapter after use.
Do not use the power adapter with an electronic product that is not in conformity with the specifications, so as to avoid any problems caused by specification mismatching.
It is normal that the power adapter will be a little overheated during the charging process.
When the power adapter stops working under over-current, over-temperature or short-circuit protection, please unplug the device after it automatically returns to work, then you need to check whether the device is compatible with this charger.
Keep the product away from fire, such as stove, candles and etc.
Keep the product away from liquid and wet surfaces.
Do not clean the power adapter with corrosive cleaner.
This product is safe to use as instructed in the user manual.

CONNECTION DIAGRAM

SPECIFICATIONS

Input	100-240VAC 50/60Hz 1.6A Max
Output

Output Four Port USB-C1: 5V,9V,15V/3A, 20V/3.25A (65W) USB-C2: 5V/3A,9V/2A (18W) USB-A1 + A2: 5V/3.4A Max(Total:17W)
Output Single Port USB-C1: 5V/3A, 9V/3A, 15V/3A, 20V/5A (100W)
Total: 100W Max

PACKAGE CONTENTS

RBWC-20025 Power Adapter
User Manual

FCC information

This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifications not authorized by the manufacturer may void the user’s authority to operate this device. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Technical Support Information techsupport@rosewill.com
1-800-575-9885 Please register your product at www.rosewill.com for complete warranty information and support for your product.
RBWC-20025_A