Rosewill RBWC-20036 2 Port Fast Power Adapter Instruction Manual
- June 6, 2024
- Rosewill
Table of Contents
RBC-20036
Thank you for purchasing a Rosewill Power Adapter. Please read the instruction manual before use and retain it for future reference.
INTRODUCTION
This product is a high-performance and fashionably designed wall charger. It is equipped with two USB-C ports which allow two devices to be charged at the same time. This wall charger is specially designed for USB-C-supported devices and can provide a total of 40W output. The unique design makes your life simpler and easier!
FEATURES
-
Input Voltage: 100-240VAC 50/60Hz 1.2A Max
-
Dual ports with different outputs: USB-C1: 5V/3A, 9V/2.22A, 12V/1.67A (20W) USB-C2: 5V/3A, 9V/2.22A, 12V/1.67A (20W) Single Port Output USB-C1 / USB-C2: 5V/3A, 9V/3A, 12V/2.52A (30W)
-
Safety Protection:
– Accurate limited current output.
– Overcurrent protection with Auto-recovery.
– Overload protection and over-voltage protection.
– Shod circuit protection with Auto-recovery.
– Over-temperature protection with Auto-recovery. -
Intelligent LED for PD charging.
OPERATION
Operation Procedures
- Plug the DC connector of the power adapter into a powered outlet.
- Plug one end of your USB cable into the power adapter and plug the other end of your cable into your device.
- Please unplug your cable from your device once it is fully charged.
Operation Notes
- For optimum performance, please use the power adapter according to the user manual.
- Please plug the power adapter into a powered outlet that has a voltage range of 100-240VAC.
- Please unplug the power adapter after use.
- Do not use the power adapter with an electronic product that is not in conformity with the specifications, so as to avoid any problems caused by specification mismatching.
- It is normal that the power adapter will be a little overheated during the charging process.
- When the power adapter stops working under over-current, over-temperature, or short-circuit protection, please unplug the device after it automatically returns to work, then you need to check whether the device is compatible with this charger.
- Keep the power adapter away from fire, such as stove, candles, etc.
- Keep the power adapter away from liquid and wet surfaces.
- Do not clean the power adapter with corrosive cleaner.
SPECIFICATIONS
| Input | 100-240VAC 50/60Hz 1.2A Max |
|---|---|
| Output | Dual Ports with Different Outputs: USB-C1: 5V/3A, 9V/2.22A, |
12V/1.67A (20W)
USB-C2: 5V/3A, 9V/2.22A,
12V/1.67A (20W)
Single Port Output:
USB-C1 / USB-C2: 5V/3A, 9V/3A,
12V/2.52A (30W)
Over Current Protection| Yes
Over Voltage Protection| Yes
Over Load Protection| Yes
Short Circuit Protection| Yes
Over Temperature Protection| Yes
Ripple and Noise| ≤200mV
Efficiency| Confirm with VI energy efficiency
| Color | White |
|---|---|
| Size | 1.87 x 1.86 x 1.09 inches |
| Weight | 2.65 Oz |
| Operating Temperature | 32-77°F |
| Storage Temperature | ~4~185°F |
| Operating Humidity | 20%~90% RH |
| Storage Humidity | 5%~95% |
| Limited Warranty | 1 Year |
PACKAGE CONTENTS
- RBC-20036 Power Adapter
- User Manual
FCC Information
This equipment has been tested and found to comply with the limits for a Class
B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifications not authorized by the manufacturer may void the user’s authority to operate this device. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Technical Support Information
techsupport@rosewill.com
1-800-575-9885
Please register your product at www.rosewill.com
for complete warranty information and support for your product.
RBWC-20036 A