DIGITUS DA-12202 On Ear Office Headset with Noise Reduction, 3.5 mm Stereo Installation Guide
- June 6, 2024
- DIGITUS
Table of Contents
DIGITUS DA-12202 On Ear Office Headset with Noise Reduction, 3.5 mm
Stereo
Introduction
The on-ear headset from DIGITUS® offers optimal voice quality. Noise reduction lowers the disruptive environmental noise on the microphone so you can concentrate fully on your call. With two jack connections, the headset can be used either as a headset or as normal earphone. With the optional headset adapter (AK-510301- 002-S), the headset can also be used on a combination jack (4-pole). Thanks to the adjustable headband, it can easily be adjusted to any head size for optimal wearing comfort. The microphone can be rotated by 300° to configure the headset for use on the right or left side. The foam cushion on the earpiece ensures wearing comfort so you can even enjoy longer phone conferences. Ideal for use in offices or at home, for phone conferences or web seminars.
System Requirements
An available 2x 3,5 mm stereo port Windows XP/Vista/7/8/8.1/10, macOS 10.4 or later
Specifications
- Connection type: 2x 3.5 mm stereo jack
- Connection cable length: 195 cm
- Microphone noise reduction (one direction)
- Earpiece diameter: 30 mm
- Headphone sensitivity: 115 dB
- Headphone impedance: 32 Ohm
- Maximum power: 84 mW
- Headphone frequency: 20 – 20,000 Hz
- Microphone sensitivity: -42 dB
- Microphone impedance: ≤ 2.2 kOhm
- Microphone frequency: 50 – 15,000 Hz
Package Content
- 1 x On-Ear Office Headset with Noise Reduction, 2 x 3.5 mm Stereo
- 1 x QIG
Installation
To use the headset, simply connect it to an available audio port on your computer. Installation on both Windows and Mac operating systems will be automatic and completed shortly after connecting the headset.
Windows
Go to Control Panel > Sound and check that the PnP Sound Device is set as the
default device in both the Playback and Recording tabs.
macOS
Go to System Preferences > Sound and check that PnP Sound Device is set as the
default device in both the Input and Output tabs. Hereby Assmann Electronic
GmbH declares that the Declaration of Conformity is part of the shipping
content. If the Declaration of Conformity is missing, you can request it by
post under the below-mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany