sOmfy 1870571 Situo 1 RTS Pure Transmitter Instruction Manual
- June 6, 2024
- somfy
Table of Contents
Situo® 1 & 5 RTS
The Situo 1 RTS remote control allows a group of one or more window
coverings to be controlled.
The Situo 5 RTS remote control allows up to 5 groups of one or more window
coverings to be controlled.
Part Numbers:
1870571 Situo 1 RTS Pure
1870575 Situo 5 RTS Pure
1870572 Situo 1 RTS Iron
1870576 Situo 5 RTS Iron
1870573 Situo 1 RTS Natural
1870577 Situo 5 RTS Natural
1870574 Situo 1 RTS Arctic
1870578 Situo 5 RTS Arctic
Introduction
Programming
Channel Selection
Situo 5 RTS
Before operating the Situo 5 RTS, ensure the correct channel has been
selected.
- Press the channel selector button (F) to choose the correct channel.
- The selection indicator lights (E) correspond to channel 1 through 4. Channel 5 is selected when all indicators lights are on.
Adding/Deleting a Situo 1 or 5 RTS
To add or delete from a window covering:
On the Situo 1 already paired with the window covering:
Press and hold the PROG button (G) until the window covering moves up and down. This step may require a paperclip because the button is recessed.
On the Situo 5 RTS to be added or deleted:
- Select the channel (F).
- Briefly press the PROG button (G) , the window covering moves up and down and the Situo 5 RTS is added or deleted.
Setting Up a Replacement Remote
-
Reset motor from motor head (motor will jog to confirm).
-
On the Situo remote, Press UP & DOWN.
-
Next, Press “my” and DOWN to set lower limit. Move motor to the desired limit position.
-
Then, Press “my” and UP to set upper limit. Move motor to the desired limit position.
-
Now, PRESS & HOLD “my” Button to confirm limit settings (motor will jog once).
-
Finally, on the back of the Situo Remote, PRESS and HOLD “Programming Button” until the motor jogs again.
Your Situo remote is not programmed and can control your RTS shade. Use the UP and DOWN buttons to confirm. -
Repeat steps again if motor limits are not properly set.
Operation
Situo 5 RTS, ensure the correct channel has been selected with the Channel
Selector Button (F)
-
A short press highlights the selected channel (E).
Channel 5 is selected when all 4 indicator lights are on. -
Pressing several times changes the selected channel.
Arrow Buttons (B)
Depending on the type of window covering to be operated:
- Up/On/Open/Tilt
- Down/Off/Close/Tilt
Stop button/“my” (C)
- Press the “my” button to stop the window covering action.
- If the window covering action has been stopped, press Up/Down button to re-activate it.
Setting, modifying, or deleting the favorite preset position “my”. (C)
- Place the window covering in the desired position then press and hold “my” button for approximately 5 seconds to set the favorite position.
- To delete the favorite preset position, place the window covering in the established favorite position by pressing “my”. Then press and hold “my” button for approximately 5 seconds.
Wall Mounting
Using the included Mounting Bracket:
- Peel the protective film from the adhesive on the back of the mounting bracket.
- Stick the wall mounting to a flat, clean, and dry surface (press firmly).
- Hang the Situo 1 or 5 on the mounting bracket.
Battery Replacement
- Remove rear panel from remote control with Phillips screwdriver.
- Insert new CR2032 battery as specified.
- Replace rear panel on remote control.
Note: Visit https://store.somfysystems.com/ to purchase an additional or replacement product.
This product is intended for indoor use only. Please keep out of
reach of children. Avoid damaging product by dropping or using undo force. Do
not expose product to open flame, heat, or moisture.
This device is FCC certified and complies with part 15 of the FCC rules. RTS
compatibility: RTS transmitters are capable of operating any RTS motor.
C-0050 10/2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>