HEXAGON HEX03DCC Radio Base Station Instructions
- June 6, 2024
- HEXAGON
Table of Contents
HEXAGON HEX03DCC Radio Base
please refer to below picture for the basic appearance.
Instruction
Status Pad
When it works normally，the Radio& safety light.
External antenna
Power cable
This cable connect to the controller to get some data from the
mechine.
Radio module
Use 2.4G BLE module for the data transfer, and USB to the board.
RF Exposure Information and Statement.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This Class B digital apparatus complies with
Canadian ICES-003.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
- This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
Antenna warning
This radio transmitter [ lC: 26848-HEX03DCC ] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated.Antenna types not included in this ist that haveagain greater than the maximum gain indicatedfor any type listed are strictly prohibited for use with this device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>