NEEWER Wireless Remote Control Instruction Manual
- June 6, 2024
- NEEWER
Table of Contents
Wireless Remote Control Operation Instructions
- Direction button
- Indicator
- Start and stop button
- Speed button
Remote control introduction
- Indicator light: when the button is pressed, the indicator light flashes to indicate that a signal has been sent, when the remote control indicator light is always on and the battery is weak, it indicates that the battery is low, just replace the battery.
- Direction buttons: you can remotely move to the right or move to the right.
- Start/stop button: press once to start, if you want to pause, press again to pause.
- Speed button: speed adjustment button.
Remote control parameters:
Remote control battery model: CR2032 lithium battery
Remote control standby time: 6 months
Continuous working time of remote control: 18H
Normal use of the remote control: 60,000 times
Wireless remote control distance: 6 meters
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The devicecan be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>