LUPINE C14 Electric Bike Rear Light Instruction Manual
- June 6, 2024
- LUPINE
Table of Contents
LUPINE C14 Electric Bike Rear Light
Assembly
Position the C14 at the rack, screw on the M4 screws and the nuts.
Note: Pay attention to the polarity (red +, black -)
Operation
The C14 lights up automatically after the drive unit was activated.
Service
The rear light turns on automatically after the drive activates became.
Hints
The rear light must not when in use covered by other objects and must be perpendicular to the roadway be aligned.
The permissible mounting height is enclosed 250 – 1200mm
For bicycles with electric pedal assistance, the supply of the lighting system via a Coupling to the energy storage done for the drive if after discharge- related shutdown of the support drive yet uninterrupted power supply to the lighting system is guaranteed for at least two hours and/or the drive motor can be used as an alternator temporarily to also continue the lighting system with electricity to supply.
Technical specifications
LED: COB LED
Power: 0.6 – 0.8 W
Voltage: 6 – 12V
Cable length: 140cm
Hole spacing: 50mm
Material: 6061-T6 aluminum anodized
Weight: 30g
Protection class: IP68/ IK09
Permit: K 1660
Lupine Lighting Systems GmbH
In the Zwiesel
D – 92318 Neumarkt
Germany
More information at www.lupine.de
EC declaration of conformity:
www.lupine.de/ce/
Documents / Resources
|
LUPINE C14 Electric Bike Rear
Light
[pdf] Instruction Manual
C14, Electric Bike Rear Light
---|---