LUPINE LIGHTING SYSTEMS C14 MAG Tail Light Instruction Manual
- June 4, 2024
- LUPINE LIGHTING SYSTEMS
Table of Contents
LUPINE LIGHTING SYSTEMS C14 MAG Tail Light
Turn On
By default, the C14 MAG can be switched on with a double click. (For other settings, see „Changing settings“).
Turn Off
Keep the button pressed for about 1-2 sec.
Factory Setting
In the factory setting, the C14 MAG lights with 0.2W, the brake light with 0.75W
Changing Settings
Keep the button pressed until the desired setting (5-8 Sec.), then release the button immediately. The C14 MAG must be switched on for this.
| Lights up 1x | Double Click on / off |
|---|---|
| Lights up 2x | A light sensor on / off |
| Lights up 3x | Brake sensor on / off |
| Lights up 4x | 0.3W mode |
| Lights up 5x | 0.5W mode |
| Lights up 6x | Reset to factory settings |
Charging
You can charge your C14 MAG with the enclosed magnetic charging cable.
Charge level indicator
During charging the status led on the button of the C14 MAG lights up.
(Lights red = charging, Lights green = fully charged)
Capacity Indicator
After switching on, a status LED next to the button indicates the capacity:
- 100 – 76% capacity = Lights green
- 75 – 51% capacity = Blinks green
- 50 – 26% capacity = Lights red
- 25 – 0% capacity = Blinks red
Light Sensor
When the light sensor is activated, the C14 MAG turns on or off depending on the ambient light. The C14 MAG must be switched on for this. When changing from darkness to brightness the sensor controlled switch off takes place with a delay of approx. 20 sec.
Brake Sensor
When the brake sensor is activated, the C14 MAG lights up brighter for a short time while braking and then switches back to the original light level.
Adjustment
-
Position the upper clamp of the holder between the saddle stays.
( Note: Do not remove the nuts, maybe you need to hold them in place) -
Position and mount the lower clamp with the enclosed screws.
Important: Make sure that the screws are only screwed in so far that they don‘t touch the C14 MAG later on. -
Now you can slide the C14 MAG into the mount.
Note: There are two different possibilities to mount the holder between
the seat stays.
Important: Only use the longer screws when mounting the C14 MAG on a
carbon saddle.
Technical Data
- LED: COB LED
- Power: 0.2 – 0.75 W
- Brake light: 0.75W
- Battery: Li-Po 4.4Wh
- Button: On/Off
- Material: 6061-T6 aluminum anodized
- Weight: 60g
- Runtime: 22h max.
- Protection class: IP68/ IK09
Address:
Lupine Lighting Systems GmbH Im Zwiesel 9 D – 92318 Neumarkt Germany
More information at: www.lupine.de
EC Declaration of conformity:
www.lupine.de/ce/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>