anslut 014520 Oil Filled Electric Radiator Instruction Manual

OIL-FILLED ELECTRIC RADIATOR
**Item no. 014520

**

OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions) This product is only intended for well- nsulated areas or sporadic use.

SAFETY INSTRUCTIONS

• Check the product, power cord, plug, and all accessories for any damage. Do not use the product if any parts are missing or damaged.
  Contact the retailer.

• Do not start the product before it is fully installed according to the instructions.

• The product is only intended for extra heating in the home.

• The product has an IP24 protection rating and can be used in bathrooms or laundry rooms. Do not place the product less than 1.5 m away from sources of water (bathtub,  washbasin, toilet). Make sure that the product cannot drop into the water, and that water cannot get into the product. Pull out the plug immediately if the product comes into contact with water or any other liquid.

• Do not use the product if the power cord or plug is damaged, if the product has been in contact with water, is not working properly, or if it is damaged in any other way.

• Take the product to an authorized service center to be checked, repaired, or adjusted.

• Never immerse the power cord or the plug in water or any other liquid – the risk of electric shock. Do not touch the product, the power cord, or plug with wet hands.

• Check that the mains voltage corresponds to the rated voltage on the type plate. The product must be connected to an earthed PowerPoint with a residual current device that has a maximum tripping current of 30 mA.

• Fully unwind the power cord before use. Do not allow the power cord to come into contact with any part of the heater and keep it away from other sources of heat. Do not lay the power cord under carpets or where it can be treading on. Make sure that there is no risk of tripping over it,  being damaged or put
  under strain. Do not lay the power cord around a corner, or fold or wind too tightly when the product is not in use.

• Do not use an extension cord unless it is a necessary-fire risk. An extension cord must be in good condition and of an approved type, with a minimum cross-sectional area of 3 x 1.5 mm²

• Connect the product to a separate power circuit.

• Do not use the product outdoors or in areas with a floor area of less than 10 m.

• Switch off the product before pulling out the plug. Never switch off the product by pulling out the plug.

• Do not use the product in an explosive environment e.g. near flammable liquids, gas, or dust.

• Do not place the product near or directly below a power outlet, or near a fire or another source of heat.

• Do not use the product near animals or place it near furniture, paper, curtains, or other flammable materials -fire risk. Do not place the product closer than 1 meter to any flammable material.

• Never cover the product-fire risk. Keep the ventilation openings on the product clean to prevent overheating and the risk of fire. Do not put anything on the product or attempt to dry clothes on it.

• Make sure that air can circulate freely around the product. Do not place the product near walls or large objects, under furniture, or in a cupboard, where there is poor circulation of air. The necessary free space for the exchange of air around the product is specified in the section on installation.

• Never insert foreign objects into the ventilation or outlet openings – the risk of electric shock, fire, and/or material damage.

• The product can be controlled manually or by remote control with a timer or app. Always follow the safety instructions, irrespective of how it is controlled.

• Switch off the product before pulling out the plug. Pull out the plug when the product is not in use. Do not pull the power cord to pull out the plug.

• Switch off the product, pull out the plug, and wait until all parts have completely cooled before handling, moving, cleaning and/or maintenance.

• The product gets hot when in use. Do not touch hot parts – the risk of getting burned.

• Keep the product under careful supervision when it is used by, or near children or persons with functional disorders. Keep small children under supervision to make sure they do not play with the product. This product can be switched on/ off by children from three to eight years old if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved. Do not allow children from three to eight years old to connect, use, clean or maintain the product without supervision.

• Keep children less than 3 years old under supervision to make sure they do not play with the product.

• The product can be switched on/off by children from 3 to 8 years old only if it is mounted in the correct position to use, and if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved. Do not allow children from 3 to 8 years old to use, clean, or maintain the product without supervision.

• This product can be used by children from 8 years and upwards and by persons with physical, sensorial, or mental disabilities, or persons who lack experience or knowledge if they are supervised or receive instructions concerning the safe use of the product and understand the risks involved. Keep children under supervision to make sure they do not play with the product. Do not allow children to use, clean, or maintain the product without supervision.

•  A damaged power cord or plug must be replaced by an authorized service center or other qualified personnel to ensure safe use.

• Keep the product clean. Dust, dirt, and deposits can cause overheating. Remove any impurities at regular intervals.

• Only use accessories recommended by the manufacturer.

• Any repairs should be carried out by an authorized service center or other qualified personnel.

• The product must only be used for its intended purpose and in accordance with these instructions.

• Do not place the product directly below a power outlet.

• This heater is filled with a precise quantity of special oil. Repairs requiring the opening of the oil container are only to be made by the manufacturer or his service agent who should be contacted if there is an oil leak.

• When scrapping the heater, follow the regulations concerning the disposal of oil.

WARNING!
Some parts of the product get very hot – the risk of burn injuries. Keep the product under careful supervision when it is used by, or near children or persons with functional disorders.
NOTE:
Failure to follow all the instructions and safety instructions can result in a risk of fire, electric shock, personal injury, and/or material damage. The manufacturer cannot accept liability for personal injury or material damage resulting from failure to follow the instructions.

WARNING: Do not cover the heater ­ risk of overheating.

TECHNICAL DATA

DESCRIPTION

1. Dial for power setting
2.  Dial for temperature setting
3. Power cord fastener
4. Radiator flanges
5. Wheel
   FIG. 1

INSTALLATION
BEFORE INSTALLATION
Remove all packaging material. Keep the packaging material out of the reach of children and pets — the risk of suffocation. Check the electric radiator, the power cord, and plug for damage. Do not use the electric radiator if any parts are missing or damaged. Contact the retailer in the event of any problems.

INSTALLATION

1. Turn the product upside down.

2. Align the mounting holes in the wheel unit to the screws on the bracket on the end radiator flange, and then fit the other wheel unit on the other end.
   FIG. 2

3. Lock the wheel units in place with the 4 wing nuts. Screw tight and stand up the product on the wheels in the required place.
   FIG. 3

USE PREPARATIONS AND HOW TO USE

• Check that the power cord and plug are intact and undamaged.
• Check that the mains voltage corresponds to the rated voltage on the type plate.
  The product must only be connected to a correctly earthed powerpoint.

STARTING AND POWER SETTING STARTING

Plugin, turn the temperature dial to + and set the power dial to the required mode. The product starts.

POWER SETTING
Use maximum power, mode 111, for quick heating. When a suitable room temperature has been reached, set mode II or I to reduce power consumption and to avoid overheating the room.

TEMPERATURE ADJUSTMENT

• Follow the instructions below if the room temperature is too high.
• Set the tern to operate redia I to mode 11 or I.
• Turn the temperature dial anticlockwise to mode- to set a lower setpoint temperature.

SWITCHING OFF
Turn the power dial to O and pull out the plug.
Turn the power dial to O and pull out the plug.

Model: 014520

Unit| Designation| Value| Unit
Heat output
Nominal heat output| Phnom| 0.8| kW
Min heat output| Pain| 0.7| kW
Max continuous heat output| Pmax, c| 0.8| kW
Electricity consumption peripheral equipment| | |
At normal heat output| elmax| 0| kW
At min heat output| Elgin| 0| kW
In standby mode| USB| 0| kW
Type of heating, only for an electric hot water heater with a container for local heating (select one)
Manual control of heat storage, with integrated thermostat| | No
Manual control of heat storage, with feedback of ro| am and/or outside temperature| No
Electronic control of heat storage, with feedback of| oom and/or outside temperature| No
Output heat fan assistance| | No
Type of control of heat output/room temperature (select one)
One-stage heat output, no room temperature control| | No
At least two manual stages, no room temperature| control| No
Room temperature control with mechanical thermostat| | Yes
Room temperature control with electronic thermostat| | No
Room temperature control with a 24-hour timer| | No
Room temperature control plus week timer| | No
Change control option (several possible)
Room temperature control with attendance detection| n| No
Room temperature control with detection of open w| window| No
Remote control option| | No
Adaptive start control| | No
Run time limit| | No
With black bulb sensor| | No
Contact: www.jula.com

Care for the environment I
Must not be discarded with household waste! This product contains electrical or electronic components that should be recycled. Leave the product for recycling at the designated station e.g. the local authority’s recycling station.
Jula reserves the right to make changes. In the event of problems, please contact our service department. www.jula.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>