BLAUPUNKT PP5.2 Portable PLL Radio USB Playback User Manual

BLAUPUNKT PP5.2 Portable PLL Radio USB Playback

Important Notes

• This safety and operating instruction should be retained for future reference.
• The apparatus should not be exposed to dripping or splashing or placed in a humid atmosphere such as a bathroom.
• Do not install the product in the following areas:
• Places exposed to direct sunlight or close to radiators.
• On top of other stereo equipment that radiate too much heat.
• Blocking ventilation or in a dusty area.
• Areas where there is constant vibration.
• Humid or moist places.
• Do not place near candles or other naked flames.
• Operate the product only as instructed in this manual.
• Before turning on the power for the first time, make sure the power adaptor is properly connected.

For safety reasons, do not remove any covers or attempt to gain access to the inside of the product. Refer any servicing to qualified personnel. Do not attempt to remove any screws, or open the casing of the unit; there are no user serviceable parts inside. Refer all servicing to qualified service personnel..

SAFETY INSTRUCTIONS

1.  Read Instructions -All the safety and operating instructions must be read before the product is operated.
2.  Retain Instructions -The safety and operating instructions should be kept with the product for future reference.
3.  Heed warnings -All warnings on the product and in the operating instructions should be adhered to.
4.  Follow instructions -All operating and users’ instructions should be followed.
5.  Installation – Install in accordance with the manufacturer’s instructions.
6.  Power sources -This product should be operated only from the type of power source indicated by the marking adjacent to the power cord entry. If you are not sure of the type of power supply to ur home, consult your product dealer or local power company.
7.  Water and moisture -To reduce the risk of fire or electric shock, do not expose the product to train, dripping, splashing or excessive moisture such as in a sauna or bathroom. Do not use this product near water, for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement or near a swimming pool (or similar).
8.  Object and Liquid Entry – Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-circuit parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. Do not place any object containing liquid on top of the product.
9.  Servicing – Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
10.  Replacement parts -When replacement parts are required, ensure that the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.
11.  The highest environmental temperature suitable for this product is 35°C.
12.  ESD hints – If the product maybe reset or not reset to operation of control due to electrostatic discharge,just switch off and reconnect again, or move the product to another location.

ERP2 (Energy Related Products) note
This product with ecodesign complies with the stage 2 requirements of Commission Regulation (EC) NO. 1275/2008 implementing Directive 2009/125/EC regard to standby and off mode electric power consumption of electronic household and office equipment.

WARNING

This appliance is not intended for use by persons (including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

1.  Never use the device unsupervised! Switch off the device whenever you are not using it, even if this only for a short while.
2.  The appliance is not intended to be operated by means of an external timer or separate remote control system.
3.  If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
4.  Before operating this system, check the voltage of this system to see if it is identical to the voltage of your local power supply.
5.  To prevent fire or shock hazard, do not expose this equipment to hot places, rain, moisture or dust.
6.  Do not place this unit close to a strong magnetic field.
7.  Do not place the unit on a amplifier or receiver.
8.  Do not place this unit in a damp area as the moisture will affect the life of electric components.
9.  If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the player. If this occurs, the system will not operate properly. Please leave the system turned on for about an hour until the moisture evaporates.
10.  Do not attempt to clean the unit with chemical solvents as this might damage the finish. Wipe with a clean, dry or slightly damp cloth.

NOTICE
Conformity Hereby, Blaupunkt Competence Center 2N-Everpol Sp. z o.o., declares that this equipment is in compliance with the essential requirement and other relevant provisions of Directive 2014/53/EU. Declaration of conformity can be obtained from the product page at www.blaupunkt.com. Responsible party: 2N- Everpol Sp. z o.o, Pulawska 403A, 02-801 Warsaw, Poland, Phone: +48 22 331 99 59, E-mail: info@everpol.pl

Your products is designed a manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2012/19/EU. Please inform yourself about the local separate collection system for electrical and electronic products. Please cat according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be dispose with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health.Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box),polystyrene foam(buffer) and poly ethylene (bags, protective foam sheet). Your system consists of material which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Recording and playback of material might require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.

Control locations

1. Display

2. Volume adjustment knob

3. IR sensor

4. Next

5. SV DC jack

6. Earphone output

7. Previous

8. Play mode

9. Power switch

10. Auxiliary input

11. Play/pause

12. Tuning knob

13. 9-FM antenna

14. 12-USB port

15.  Play mode

16.  Standby

17.  Play/pause

18.  FM auto scan

19.  Digits keyboard

20.  Repeat button( repeat one/repeat folder/repeat all/random)

21.  Mute

22.  Previous/next

23.  Volume up/down

24.  FM radio

Note : Please remove the battery (CR2025) insulation sheet before using the remote controller; the best working distance is within 5 meters without obstacle in between; please try your best to aim the IR sensor during operation.

Power setting and battery charging.
There have built in rechargeable battery inside of this unit. Before play the speaker, please follow up below step to charge the unit first.

1.  Using the supplied USB cable to connect the DC 5V jack on the rear panel, and another terminal connect with supplied USB DC power adaptor. Then plug on the DC power adaptor to AC power source.
2.  During the charging, the rear panel red LED indicator will turn on, and will off after be fully charged (2~3 hours charging time).
3.  During the battery power playback mode, the unit will stop play and display off when the power is too low. Please connect power for re-charging and playing.
   Note: Your battery will last longer if you following these simple guidelines for charging and storing.

•  For charging first time, charge it at least 10 hours. And the battery will provide the best performance after fully charge and discharge 3 times. It is better to charge the unit after discharge completely, otherwise there may affect the battery’s lifetime.
•  Recharge and store the unit within the temperature range of 5°C~35°C (40°F~95 ° F).
•  Do not charge (longer than 24 hours). Excessive charging or discharging may shorten the battery’s life.
•  Due to prolong charging and discharging, the unit battery life will be affected and playback will be shorten. We cannot guarantee the same playback consistently throughout and this is not include in our warranty and service.
•  During charging, you can play the music at the same time.
•  Please do not use it under the high humidity and temperature environment for long time.
•  Please turn off the speaker if long time not to use.

Unit power on
Slide the power switch to”on” position on rear panel to power on the unit, and slide to off position to power off (display off). Short press the power button on remote controller to standby on/off the unit. In case of you off the unit by side the power switch on rear panel that you cannot power on the unit by remote controller because the power is cut off completely.
Time setting
Press the mode button repeatedly until enter to clock time interface. Long press (2 seconds) the mode button until hour’s digits flare on display, rotate the volume knob to adjust the hour setting, short press mode button to confirm and skip to minute setting, rotate the volume knob to adjust it and press the play/pause button to finish the time setting. In case of you power off the unit by remote controller, the clock time will show 15 seconds and disappear on display automatically; short press any one button from panel or remote controller(except power button), the clock time will show 1 0 seconds on display in case of you need check the time. Note :The clock time may reset in case of battery power exhausted, and without DC power connection. You may need set up it again after charging.
FM RADIO
Before to do the FM reception, please extent the telescope FM antenna as long as it can be. Please place the unit next to window for better reception. If the FM reception is not good, please try to move other place for reception. FM play: Slide the power switch to”on’ position on rear panel to power on the unit. There will have” HI” show on display and skip to FM mode directly. Press and hold play/pause button 3 seconds, the unit will auto tune and save the FM radio station automatically. Max support 60 preset stations. Short press the previous or next button will select and play previous or next preset station. Press and hold previous or next button will auto scan the available FM station in forward or backward frequency. Short press play/pause button will mute the unit. Rotate the volume knob to adjust the output volume level; Max volume is 30, and default volume 18. Rotate the tuning knob to adjust the FM frequency by 0.1 MHz each step.
FM operation by remote controller:
press FM scan button shortly to start auto scan and station preset function automatically , repress it shortly to stop auto scan and play first preset station; press previous button shortly to decrease FM frequency by 0.1 MHz each step, press previous button longer time to auto scan in backward, and stop till get the available station; press next button shortly to increase FM frequency by 0.1 MHz each step, press next button longer time to start auto scan forward, and stop till get the available station. Inputting 1 or 2 digits from the remote control’s digits button part can get and play the preset stations. For example, there have 20 preset station ready in unit, if press 1 and 5 number from remote control, 0015 will display, then the unit will switch to”P15″ preset station and play. If you also input 3 digits or 4 digits from remote control, the unit will play and get the correspondence FM frequency stations between 87.5-108MHz. For example, if you input 1043 from remote control, then 1043 will show on display and play FM station frequency at 104.3MHz.
USB playback operation
Before start the USB playback operation, please insert the USB into the relative slot on the rear panel first, the unit only can detect and playback the USB when there have available device in the slot. Slide the power switch to” on’ position on rear panel to power on the unit. The unit will read out and play the USB device automatically after show” HI” on display. While the USB mode is playing, short press play/pause button for play/pause control; short press previous/next button for previous or next track selection; press and hold previous/next button for fast backward or forward selection and resume play after release the previous/next button.

Fast selection:
press digits 0-9 key from remote control to choose song, input 2 digits if there have saved over 1 0 tracks in the device; input 3 digits if there have saved over 100 tracks in the device. For example, if you want enjoy the number 105 song, please press 1, 0, and 5 from remote control, then 0105 will display and play.
AUX IN and headphone.
Using the supplied 3.5mm audio cable plug into the AUX IN jack on rear panel, and the other terminal connect to other relative audio player. Power on the unit or press the mode button switch to AUX mode. Select the music from your player device and play. The sound will output from the speaker. You can get the volume up/down, MUTE, play and pause function in AUX mode.
In any play mode, if you insert headphone into the headphone jack on rear panel, there will no sound output from the speaker, but via headphone.

SPECIFICATION

• Input: FM radio, AUX in, USB
• FM frequency range: 87.5 ~ 108 MHz.
• USB: 2.0 version
• USB max supported capacity up to: 32GB.
• Output RMS power: 1.SW x 2
• DC IN: 5V/0.6A
• Battery: 3.7V/1 000mAh lithium battery
• Battery playback time: 3-4 hours.
• Charging time: 2~3 hours.
• Power consumption: SW.
• Standby power consumption:< 0.5 W.

Troubleshooting

1.   No sound output
   There is no power in battery. Please reference the manual and connect power source for charging. Please power off the unit and power on again.

2. Cannot get USB play mode.
   Please double check if you have inserted the USB on the rear panel already.

3. FM reception is not good.
   Please extent the antenna as long as it can be. Please move the unit to other place for reception.

4. The remote control does not work properly.
   Please use the remote control straight direct to the front display and move close for control.

Competence Center
2N-Everpol Sp. z o.o. ul. Putawska 403A 02-801 Warsaw, Poland

• phone: +48 22 331 99 59
• e-mail: info@everpol.pl
• www.blaupunkt.com

All rights reserved. All brand names are registered trademarks of their respective owners. Specifications are subject to change without prior notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>