Starkey FLYR3469-04-EE-GS TV Streamer User Guide
- June 6, 2024
- Starkey
Table of Contents
Starkey FLYR3469-04-EE-GS TV Streamer
Pairing
The TV Streamer must be paired to interact with compatible 2.4 GHz hearing aids on the Thrive platform. Pairing occurs once, then the hearing aids and TV Streamer will automatically recognize each other.
- Power off your smart device or other accessories that were previously paired with your hearing aids.
- Ensure the TV Streamer is powered on.
- Power off, then power on your hearing aids to place in pairing mode.
- Place your hearing aids within 6 inches of the TV Streamer.
- Press the pairing button on the TV Streamer to place it in pairing mode. The LED will rapidly blink blue.
- Once the LED blinks green for each hearing aid, both hearing aids are paired.
Basic Setup
- Power Supply Jack (micro USB)
- Toslink Jack
- Analog 3.5mm Jack
- Mono/Stereo Switch
- Remove the plastic caps from each end of the TOSLINK cable.
- Plug the TOSLINK cable into the Audio OUT jack of your television. If there is no TOSLINK audio OUT jack, use a 3.5mm to RCA cable.
- Power on your television.
- Plug the other end of the TOSLINK cable into the rear of the TV Streamer B .
- Insert the power adapter micro-USB connector into the rear of the TV Streamer A.
- Plug the power adapter into the wall socket.
- Turn on the TV Streamer. A solid green LED indicates power is on.
- A solid blue LED indicates the TV Streamer has detected audio and is streaming.
Use
- An unlimited number of 2.4 GHz hearing aids can connect to the TV Streamer at one time, allowing multiple people to share in the same listening experience.
- The TV Streamer can be successfully connected to many electronic audio sources including televisions, computers, MP3 players, DVD players, cable boxes, Bluetooth®, or Amazon Echo and Echo Dot (3.5mm Jack).
- To adjust the stream volume, press the + or – buttons on the TV Streamer. Volume can also be adjusted via the hearing aid user controls, the Remote Control accessory (if applicable), or the Thrive Hearing Control app.
Audio streaming may be started/stopped in several ways:
To start/stop the audio stream, double-tap your hearing aid.1 You can also
start/stop the audio stream via the push & hold hearing aid user control (if
enabled by your clinician), the Remote Control accessory (if applicable), or
in the Thrive Hearing Control app.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>