HFCL ION4 Dual Band 2X2 Indoor-Outdoor Access Point Installation Guide
- June 6, 2024
- HFCL
Table of Contents
HFCL ION4 Dual Band 2X2 Indoor-Outdoor Access Point
Installation Setup
IO Indoor AP can be mounted onto the wall or ceiling. Perform the steps discussed in below sections for the appropriate installation of indoor AP:
Mounting of Dual Band 2×2:2 Indoor Access Point (Wall and Ceiling)
-
Refer the image below for attaching parts required for wall/ceiling mounting of AP:
-
Place the attaching bracket on to the wall or ceiling and mark the holes to drill. Drill holes of appropriate size.
-
Insert the foundation bolts in the drilled holes of wall/ceiling.
-
Use the supplied screws and mount the attaching bracket on to the wall or ceiling as shown below:
Note: Make sure that the attaching bracket is tightly installed before mounting the access point on the wall or ceiling.
-
Refer the image below for wall mounted attaching bracket:
-
Align the mounting slots of indoor AP and attaching bracket as shown below:
-
Refer the image below for backside view of wall/ceiling mounted AP:
-
The wall or ceiling mounted AP is shown below:
-
Slightly push and slide the access point out from the mounting slots of attaching bracket to unmount the AP.
Use Cases
A. Indoor Access Point