HOME ACCENTS Holiday 1006215551 Illusion Projector Angel User Guide
- June 6, 2024
- HOME ACCENTS Holiday
Table of Contents
**HOME ACCENTS Holiday 1006215551 Illusion Projector Angel User Guide
**
Do not plug in the projector onto an outlet until it is fully assembled and the projector is properly connected
Please read the enclosed important safety instructions and warnings carefully prior to use and save these instructions for reference.
PACKAGE CONTENTS
-
Projector x1
-
Adapter x1
-
Stake Set x1
-
Base x1
PRODUCT SPECIFICATION
Input: 120V~ 60Hz, 0.2A
Lights: White LED
Operation: Indoor/outdoor
Operating Temperature: -15°F to 90°F (-26°C to 32°C)
Dimension: 4 in x 5.5 in x 15 in
Projection Coverage: 8.5ft x 8.5ft
Maximum Projection Distance: 23ft
Warranty: 3 Years Limited
OPERATION
- Plug in to turn the projector on and the timer will be set on automatically for 6 hours on and 18 hours off.
- Press the button on the back of the projector to turn it off and on.
- Once turn off and re-turn on, timer will be reset.
INSTALLATION
-
Screw to connect the assembled stake with the projector securely. Or screw to connect the base with the projector securely.
-
Connect the adapter as below figure shown
CAUTION
- To reduce risk of danger:
- Do not break the projector in anyway as this may damage wire insulation.
- Do not attempt to open the housing of LED projector or modifying the LED projector as it will void all warranties.
- Do not use in a bathroom.
- Do not secure the wiring of the product with staples or nails or place on sharp hooks or nails.
- Do not operate unit with damage plug.
- Do not operate unit if it has been subjected to damage in anyway
WARNING
- Always ensure light set is unplugged when installed
- This is an electric product-not a toy! To avoid risk of fire, burns, personal injury and electric shock, it should not be played with or places where children can reach it.
- Do not use this product for other than its intended use.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
FCC CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The Customer care call number: 1-877-527-0313
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>