JL AUDIO C5-075ct-SINGLE 0.75-Inch 19 mm Component Tweeter Owner’s Manual

JL AUDIO C5-075ct-SINGLE 0.75-Inch 19 mm Component Tweeter Owner's Manual

C5-075ct-Single

Included Components and Parts:

• One C5-075ct-Single 0.75-inch (19 mm) Tweeter
• One Surface-Mount Tweeter Fixture
• One Flush-Mount Tweeter Fixture
• One Swivel Assembly for Flush-Mount Tweeter Fixture
• One Metal Spring Clip for Flush-Mount Tweeter Fixture
• One M4 x 30 mm Machine Screw
• Two #6 x I-inch (25 mm) Sheet Metal Screws
• Two 2.8 mm Male Crimp able Connectors
• One 15 μf Tweeter Protection Capacitor

Specifications:

Speaker Type: Component Tweeter
Nominal Diameter: 1 in (25 mm)
Design Bandwidth: 4 kHz – 25 kHz
Nominal Impedance (Zoom): 4 ohms
Continuous Power Handling: 7SW (RMS] Recommended Amplifier Power: 15-150W (RMS)
Net Weight: 0.12 lbs. (52 g)

Parameters:

Voice Coil Resistance (Re): 3.089 ohms
Free Air Resonance (Fs): 1900 Hz
Efficiency@1W/1m: 90.5 dB SPL
Sensitivity@2.83V/1m: 93.5 dB SPL

Design Bandwidth:

With 48 dB/octave filters: 4 kHz – 25 kHz
With 24 dB/octave filters: 5 kHz – 25 kHz
With 12 dB/octave filters: 6 kHz- 25 kHz

Crossover Setting Guidelines: 3-Way Speaker Systems
C5-650cw-Single Woofer
Low-Pass: 24 dB/octave Linkwitz-Riley@ 300 Hz
Level Offset: -1.0 dB

C5-400cm-Single Midrange
High-Pass: 12 dB/octave Linkwitz-Riley @550 Hz
Low-Pass: 12 dB/octave Linkwitz-Riley@ 7000 Hz
Level Offset: 0 dB

C5-075ct-Single Tweeter
High-Pass: 24 dB/octave Linkwitz-Riley @ 7000 Hz
Level Offset: -0.5 dB

C5-570cw-Single Woofer
Low-Pass: 24 dB/octave Linkwitz-Riley@ 300 Hz
Level Offset: -2.5 dB

C5-400cm-Single Midrange
High-Pass: 12 dB/octave Linkwitz-Riley @550 Hz
Low-Pass: 12 dB/octave Linkwitz-Riley@ 7000 Hz
Level Offset: 0 dB
C5-07Sct-Single Tweeter
High-Pass: 24 dB/octave Linkwitz-Riley @ 7000 Hz
Level Offset: -0.5 dB

Crossover Setting Guidelines: 2-Way Speaker Systems
C5-6S0cw-Single Woofer
Low-Pass: 24 dB/octave Linkwitz-Riley@ 5500 Hz
Level Offset: 0 dB
C5-07Sct-Single Tweeter
High-Pass: 24 dB/octave Linkwitz-Riley @5500 Hz
Level Offset: -1.0 dB

CS-570cw-Single Woofer
Low-Pass: 24 dB/octave Linkwitz-Riley@ 5000 Hz
Level Offset: -1.0 dB
C5-075ct-Single Tweeter
High-Pass: 24 dB/octave Linkwitz-Riley@ 5000 Hz
Level Offset: -1.0 dB

C5-525cw-Single Woofer
Low-Pass: 24 dB/octave Linkwitz-Riley@6000 Hz
Level Offset: 0 dB
C5-075ct-Single Tweeter
High-Pass: 24 dB/octave Linkwitz-Riley @6000 Hz
Level Offset: 0 dB

Please note: These a re recommended standing points for tuning.
In-vehicle measurements should be made to optimize the absolver
for speaker placement and vehicle acoustics. Because of vehicle
acoustics, the use of equalization will be required to achieve flat
frequency response characteristics. Individual results may vary.

INTRODUCTION

The C5-075ct-Single is a component tweeter designed to operate in a 3-way system, with a woofer and midrange, or with only a woofer in a 2-way configuration.

Passive crossover networks are not included with CS-Single drivers, as they are designed for active systems. Actively configured systems allow all filtering and/or equalization to be configured prior
to reaching the amplifier, thus avoiding the technical compromises of passive crossover networks.

For optimum performance, we strongly recommend the use of a high-quality DSP and a dedicated amplifier channel. Precise setup of
equalization, delay and crossover filters will ensue optimal in -vehicle performance.

Should you have any questions regarding the instructions in this manual, please contact your authorized JL Audio dealer for assistance, or contact the JL Audio Technical Support Department.

FLUSH-MOUNT TWEETER INSTALLATION

SURFACE-MOUNT TWEETER INSTALLATION

TWEETER / PROTECTION CAPACITOR WIRING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>