POWER CAST PTM-520K Wireless Charging Module User Guide
- June 6, 2024
- POWER CAST
Table of Contents
POWER CAST PTM-520K Wireless Charging Module
Feature
-
Input voltage/current: DC 5V 2A
-
Output voltage/current: DC 5V 1A
-
Frequency: 110 ~ 129 kHz
Charging efficiency ≥ 70% -
Operation Temperature: -30 ~ 45
Note on Wireless charging
Depending on the location of the charging coil on your mobile device, your
device may not charge in all positions. Find the position that works best for
your device.
Wireless charging may not work if you have a case that is A) too thick or B)
has a magnet. In order to charge, you will need to remove the case before
placing on the charging pad.
If you are using an attached wireless charging case on your mobile device,
never place just the case on the charging pad. This may overheat the charging
pad and/or the case, and has a risk of fire and injury.
If you connect a wired or portable battery charger to your device while it is
on the charging pad, the pad will disable wireless charging.
Precautions
- Do not drop the Wireless charging module from high places.
- Do not modify, repair, or take the Wireless charging pad apart.
- Do not clean with water alcohol or benzene.
- Keep the Wireless charging pad away from humidity & dust.
Declaration of confirmation
FCC NOTICE TO USERS: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference and
- This device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
DANGER to reduce the risk of electric shock
- Do not reach for a device that has fallen into water. Unplug it immediately.
- Do not place in or drop into water or other liquid.
WARNING to reduce the risk of burns, fire, electric shock or injury to persons
- Use this device only for its intended use as described in this manual. Do not use with unauthorized accessories of devices.
- Never operate this device if it has a damaged plug, cable or Coil.
- Keep cable away from heated surfaces.
- This device is designed for indoor use only. Do not use outdoors.
This product can be used in which EU members, in accordance with Article
10(10) /
or this product can be used in at least one EU country, in accordance with
Article 10(2).
This device complies with FCC & IC radiation exposure limits set forth for an uncontrolled environment. This module may not be co-located with any other transmitters or antennas. The antenna must be installed such that 20cm is maintained between the antenna and users.
FCC Label
Model name: PTM-520K
FCC ID: 2A2GT-PTM-520K
Manufacturer:
POWER CAST CO., LTD.
Ver 0.1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>