San Ford Machinery ZF1530-K4S Handheld Remote Control Instructions

Dust Cyclone- Remote control panel function
SF-H01A
PROGRAMMING INSTRUCTION
FOR HANDHELD REMOTE CONTROL-ZF1530-K4S

Button A : ON button. Turns the cyclone ON, the Power indicator light will illuminate.
Button B: OFF button. Turns the cyclone off, the Power indicator light will go off.
Button C: CLEAN button. Starts to clean cartridge filter, rotate clockwise (10s) and anti-clockwise (10s) for a cycle.
Button D: RESET button. Press SW1 or Reset button from remote switch until you hear two beeps. Press the RESET Button from handheld remote control until you hear three beeps to complete the set up.

Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ISED Canada Statement:

This device contains license-exempt trasnsmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada ‘s licenceexempt RSS(s). Operation is subject to the following two conditions:

1. this device may not cause interference and,
2. this device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure:
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment RF Exposure Statement To maintain compliance with IC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 5mm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>