ZEAPON AF-E1 Timeplase Trigger Instruction Manual
- June 6, 2024
- ZEAPON
Table of Contents
Timelapse Trigger
AF-E1
Operating Instruction
Product Description
Do not block the infrared emission area during use! The delivered USB cable is for time-lapse trigger charging only!
Timelapse Trigger Connection Method
Insert the timelapse trigger into the camera
Tighten the hot shoe lock nut to secure the timelapse trigger
App User Guide
Timelapse Trigger and at least one other ZEAPON device are connected to the app at the same time
Enter Video Mode
Tap the record button after setting two or more waypoints, The camera starts recording while the device starts, (Only Sony cameras with infrared control are supported)
Enter Camera Mode
After setting two or more waypoints,
Set the interval shooting parameters on the camera,
Fitt the number of photos of the parameter into the parameter box of a number
of photos under the app Camera Mode
Then press the shutter of the camera to start shooting
Firmware Upgrade
Tap the setting button on any interface
Select the corresponding device from the Firmware Upgrade Menu
If you are prompted that the upgrade failed, please reset by pressing the
timelapse trigger reset button and trying again
Important:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for Class B digital devices, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determ fined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operated in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. in
portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>