METAL SL-212A Radio Control 2.4G Racing Car User Manual

USER MANUAL
05#
AGE 8+

( ABOUT THE RC CAR )

The RC car adopts 2.4G technology to control functions such as forward, backward, left, and right turning and multiplayer competition without interference. The design such as powerful motor and antiskid tires makes stable driving of the car possible, bringing you an ultimate experience full of speed and thrill!

1. ON/OFF Switch

2. Battery Compartment

3. Battery Compartment Screw

4. Rechargeable Battery.

5. Battery Connector

6. Direction Fine-tuning

7. ON/OFF Switch

8. Indicator Light

9. Forward/ Backward Trigger

10. Steering Wheel

( ACCESSORIES )

( PREPARATIONS )

3.1 Charge the Battery for RC Car

1. Unscrew the screws on the battery compartment in the car with a screwdriver, and then open the battery cover.
2. Connect one end of the USB charging cable to the battery connector and ensure it is correctly connected. Then insert the other end of the USB charging cable into safe power supplies with USB socket, such as PC, laptop, mobile power, or USB power socket, etc. The red light turns solid on during charging and goes out when charging completes. Full charging takes around 3 to 5 hours. 3.
3. After charging, connect the battery with the battery connector and ensure it is correctly connected.
4. Insert the battery into the battery compartment, refit the battery cover, and finally tighten the screws with a screwdriver

NOTICE:

• Juveniles shall be accompanied and guided by their guardians to charge the product.
• It is recommended to fully charge the battery to ensure sufficient power before the first use. Please understand that the running time will be relatively shortened without prior charging for the first use due to insufficient power of the battery, which is caused by the auto discharge during transportation.
• Do not charge batteries that are inflated, leaked, or damaged. Do not overcharge the battery.
• Please use the original USB charging cable from the factory. Do not use charging cables that are damaged or non-original ones.
• Keep it away from flammable materials and do not put it on the surface of conductive objects(such as carpet, wooden floor or furniture, etc.) during charging.
• Please be careful to avoid electric shock while using electrical products.

3.2 Install the Battery for Remote Controller
STEPS

1. Use a screwdriver to unscrew the screws on the battery compartment of the remote controller and open the battery cover.
2. Install Two new 1.5V AA batteries (not included) into the battery compartment and make sure the “+” and “-“of the batteries match with those indicated inside the compartment.
3. Refit the battery cover and tighten the screws.

3 3 Drive-in Suitable Environment

USE 2X1.5V “AA” BATTERIES (NOT INCLUDED)
NOTICE:

• Please ensure the “+” and “-” electrodes have been correctly aligned.
• Do not mix old and new batteries.
• Do not mix different types of batteries.

NOTICE:

• Do not use it in conditions like rains and snowstorms etc. to avoid accidents.
• Do not use it on public roads to avoid impacts on the traffic.
• Do not use it near crowded places, people, or animals to avoid environmental damage or bodily injury.
• Do not use it in the rain or let the car run over the puddle to avoid malfunction.
• Do not use it near rivers, ponds, or lakes to prevent the car from falling into the water.

( DRIVE VIA REMOTE CONTROL )

STEPS

MAINTENANCE

TROUBLESHOOTING

terminals are correctly aligned
aLow battery voltage.| 3. Replace the batteries of the remote controller/ Recharge the batteries for the RC car
4.0ut of control range.| 4. Control it within 45 meters.
5. RC car not paired with the rents controler.| 5.Poi.ver off the RC car and the remote controller and then tun on again and par again.
control  Close-range.| 1. Signal interference around.| 1. Try to drive to another place.
2Low battery voltage of RC cal remote =troller.| 2. Replace the batteries of the remote controller/ Recharge the batteries for the RC car.
RC car fails to drive in a straight line.| 1. Excessive surface friction or extremely smooth surface.| 1. Try to drive to another place.
2Fai to activate the fine4uning function.| 2. Toggle fine-tuning switch to trim the directions.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

The device must not be co-located or operating in conjunction with any other antenna or transmitter.

SL-212A

Documents / Resources

| METAL SL-212A Radio Control 2.4G Racing Car [pdf] User Manual
SL-212AT, SL212AT, 2AZCSSL-212AT, 2AZCSSL212AT, SL-212A, Radio Control 2.4G Racing Car
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>