Metal Water Finder B07HQWCLG5 Gold line Underground Depth Scanner User Manual

: June 6, 2024
: Metal Water Finder

Table of Contents

Metal Water Finder B07HQWCLG5 Gold line Underground Depth Scanner
Safety information
Technical speciﬁcation
Device parts
Interfaces
Starting
Charging
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Metal Water Finder B07HQWCLG5 Gold line Underground Depth Scanner

Safety information

Metal Water Finder B07HQWCLG5 Gold line Underground Depth Scanner-
fig2

The user must practice before starting the detecting operations and discoveries
Store in Cool and dry place 15-40 C 5%-75% humidity

Technical speciﬁcation

Metal Water Finder B07HQWCLG5 Gold line Underground Depth Scanner-
fig3 Metal Water Finder
B07HQWCLG5 Gold line Underground Depth Scanner-fig4

Device parts

Main Control Unit
- The unit is responsible to control of the settings and search options.
- The batteries was built inside it.
- Also it’s responsible to issuing the search acoustic , optical and vibrations results.
Ion and Radar sensor.
This sensor needs to connect into its own entrance at the front of the device by using connectivity socket.
Hand held
It uses for hold and control the device.
The hand held has laser button on the front section. and the charging socket at the bottom
Charger
An electric charger to recharge the device’s battery Values: Input: 240-100VAC / 60-50Hz / 0.4 amps
Output: 5 volts AC / 3 amp / 15 Watt.
Headphones
Needs to contact through the headphones jack, who is to the right side of the device.

Interfaces

Ionic sensor input
Night light
Visual signal indicator
ON/OFF key
Battery indicator
Ground calibration button
Volume button
LED button
laser button
Charge socket

Device Aggregation

Starting

Power button: Press and hold to turn on the unit after switching the power switch ON.
LED flashlight button: press the button to turn the ashlight in the front of the unit for ease of use in night. Keep in mind that working with flashlight increases the power consumption and therefore less working hours.
Volume button: press the button to select the sound level
Ground calibration key: With this key, the user can adjust the unit to adapt to the terrain and environment in which the device operates. The device gives the normal and stable adjustment of the search tool for better results. Note: We may start searching in an area where the device is issuing a signal in generalWe press the calibrate key once and wait for the signal to stabilizeIf this continues to sound in any direction we press the key again until we get a stable result and then go to the search area to determine the targets.There are three levels to adjust the calibration if the device is not calibrated. You are located in areas where there is high noise from high voltage, etc.

Starting
To use the Verification Unit ,First move away from suspected target location and calibrate the device by pressing the balance button, then start moving around the target location. The unit will react according to the target ionic field indicating sound and visual signals. The signal will increase when the unit is near the target.

Note:
The ionic field intensity depends on the metal type and the period that been underground.

Note:
The approximate depth of the target can be determined by using this unit. After the target point is determined, direct the target to the target and walk in any direction until the acoustic indicator is disconnected. We measure the distance from this point to the target point, which is the approximate distance to the depth of the target.