Donggan Changan Bestfull Metal SDWC Smart Digital Lock for Cabinet Instructions
- June 6, 2024
- Donggan Changan Bestfull Metal
Table of Contents
Donggan Changan Bestfull Metal SDWC Smart Digital Lock for Cabinet
PRODUCT SPECIFICATION
Working Current 330mA
Working Voltage 4.SV
Working Temp. o·c ~40•c
Working Humidity 20%-80%
CARD INTRODUCTION
MANAGEMENT {PROGRAMMING) CARD:
(Management card will first need to set up)
The management card is used set up or delete user card.
It should not be used to open or close a lock unless in an emergency.
USER CARD (THE KEY OF THE LOCK):
(Use management card to set up user cards)
The user card Is for an user to open or close the lock..
It is capable of storing 49 cards per lock.
BUTTON INTRODUCTION
BUTTON A/ MODE: Mode switch button
(Short press button A to switch the mode, you will hear beep sound once
pressed)
BUTTON B/SET: Set I Reset button
MODE INTRODUCTION
-
MANUAL.CLOSE MODE (“BEEP” SOUND):
Door will not lock until user card touch the sensor. -
AUTO-CLOSE MODE (“BEEP BEEP” SOUND)
Door will be locked after 6 seconds. -
PUBLIC MODE {“BEEP BEEP BEEP” SOUND):
When a card is scanned. the dOOf’ will keep locked until the same card scans again to unlock the door.
The locker will be available for next user. Once the management card is scanned. the registered card will be disabled and the locker will be open for next user.
LOW VOLTAGE ALARM
- When you scan the card to the sensor and !l0U hear ‘beep beep beep beep beep beep beep beep” some, l means the lock is in low power .ial>Js. The lock can only be used around 24 hours. Please change lo new batteries immediately.
- Locks with a port for an external power supply will remain the locked if batteries completely die.
- Locks without the pen for an external power supply will fail open if the batteries completely die (voltage under 3.7V).
WARNING:
- PLEASE TEST LOCK IF IT CAN WORK BEFORE CLOSING THE DOOR,
- PLEASE USE NEW AAA ALKALINE BATTERIES.
- VOLTAGE INPUT CANNOT BE MORE THAN 6.5V.
Please keep door open when set up/delete the card
Do not use management card to open/close a lock
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>