Shen Zhen Gtl Technology CW350 3-In-1 Fast Charger Instruction Manual
- June 6, 2024
- Shen Zhen Gtl Technology
Table of Contents
Shen Zhen Gtl Technology CW350 3-In-1 Fast Charger
Introduction
- Wireless charging area of mobile phone
- Charging plug of Bluetooth headset
- Wireless charging area of watch
- Operating Indicator
- TYPE-C Female
Operation instructions
Charging the mobile phone: Put the mobile phone upright in the wf,reless charging area of mobile phone, and you can see the “Charging indicator” on the display of the mobile phone, showing that it is being charged properly. (Attention: The phone cannot be charged when placed horizontally Charging the watch: Put the watch on the wireless charging area of watch. and align the magnets; the •charging Indicator• on the watch will light up, Indicating that It ls being charged properly.
Charging the Bluetooth headset: Insert the plug to the Bluetooth headset
charging compartment (Attention: If a thick silicone protective cover is
provided on the headset charging compartment, It may cause poor contact and
failure to charge, please remove the silicone protective cover before
charging. This product needs to be powered with an adapter with a power of
9V—2A and connected to the type-c port, When the bottom power Indicator is on,
it means that the power supply is connected.
Operating Indicator: The blue working indicator is always on during the
charging process of the mobile phone, which is off when it is not being
charged or fully charged; It will flash in case of any charging fault
Specifications
| Name | 3 in 1 wireless charger | Model | CW350 |
|---|---|---|---|
| Product size | 100 ‘114.5 • q1.1 (mm) | Power Supply | |
| Port | TypeC | ||
| Input | 9V=2A | Maxi mum output oower | 18W |
Matters needing attention
- When charging the device, do not use a protective cover with a thickness of more than 5mm, and do not use a protective cover with a metal sheet.
- Do not put metal foreign objects in the charging area.
- When charging, please aim the device at the center of the charging area.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for WPT device:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>