PORSCHE DESIGN PDH80 Wireles Over Ear Space One Headphones User Manual

PORSCHE DESIGN PDH80 Wireles Over Ear Space One Headphones

Important safety instructions

Danger

• To avoid hearing damage, limit the time you use headphone at high volume and set the volume to a safe level. The louder the volume, the shorter the safe listening time is.
  Be sure to observe the following guidelines when using your headphone:

• Listen at reasonable volumes for reasonable periods of time.

• Be careful not to adjust the volume continuously upwards as your hearing adapts.

• Do not turn up the volume so high that you cannot hear what is around you.

• You should use caution or temporarily discontinue use in potentially hazardous situations.

• Excessive sound pressure from headphone can cause hearing loss.

• Using headphone with both ears covered while driving is not recommended and may be illegal in some areas.

• For your safety, avoid distractions from music or phone calls while in traffic or other potentially dangerous environments.

**To avoid damage or malfunction:

Caution**

• Do not expose headphone to excessive heat.
• Do not drop your headphone.
• Headphone shall not be exposed to dripping or splashing. (Refer to the IP rating of specific product.)
• Do not allow your headphone to be submerged in water.
• Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives.
• If cleaning is required, use a soft cloth, if necessary dampened with a minimum amount of water or diluted mild soap, to clean the product.
• The integrated battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Danger of explosion if battery is incorrectly replaced.
• Replace only with the same or equivalent type.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting a battery, can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

Operating and storage temperatures and humidity:

• Store in a place where the temperature is between -20°C (-4°F) and 50°C (122 °F) with up to 90% relative humidity.
• Operate in a place where the temperature is between 0°C (32°F) and 45°C (113 °F) with up to 90% relative humidity.
• Battery life may be shorter in high or low temperature conditions.
• Replacement of a battery with an incorrect type risks severely damaging the headphone and the battery (for example, in the case of some lithium battery types).

Your Wireless Headphone

Congratulations on your purchase, and welcome to Porsche Design! With the Wireless Headphone you can:

• Enjoy convenient wireless handsfree calls.
• Enjoy and control music wirelessly.
• Switch between calls and music.

What is in the box

• Porsche Design Wireless Headphone PDH80

• Replaceable rubber ear tip covers x 3 pairs

• USB-C charging cable (for charging only)

Other devices
Requires a mobile phone or device (e.g. notebook, tablet, Bluetooth adapters, MP3 players, etc) which supports Bluetooth and is compatible with the headphone (see ‘Technical data’ on page 10).

Overview of your Wireless Headphone

1. ANC / Awareness mode button
2. Voice assistant
3. (Power button)
4. Touch control panel
5. LED indicator
6. Audio jack Microphone
7. USB Type C charger slot

Get started

Charge the battery
Note

• Before you use your headphone for the first time, place charge the battery for two hours for optimum battery capacity and lifetime.
• Use only the original USB-C charging cable to avoid any damage.
• Finish your call before charging. Connecting the headphone to charge will power them off.

Plug one end of the USB-C cable into the headphone and the other end into the power source.The headphone starts charging.

• Charging process is verified by a white LED light on the headphone.
• When the headphone is fully charged, four LED indicators turn on.

Tip

• Normally, a full charge takes two hours.

Pair the headphone with your Bluetooth device for the first time
Before you use the headphone with your mobile phone for the first time, pair it with a mobile phone. A successful pairing establishes a unique encrypted link between the headphone and mobile phone. The headphone stores the last four devices in the memory. If you try to pair more than four devices, the earliest paired device is replaced by the new one.

1. Make sure that the headphones are fully charged and turned off.
2. Press and hold for five seconds until the blue and white LED flashes alternately.The headphone remains in pairing mode for three minutes.
3. Make sure that the mobile phone is turned on and its Bluetooth feature is activated.
4. Pair the headphones with the mobile phone. For detailed information, refer to the user manual of your mobile phone.

Note
After powering on, if the headphone cannot find any previously connected Bluetooth device, they will automatically switch to pairing mode.

The following example shows you how to pair the headphone with your Bluetooth device.

1. Turn on the Bluetooth function of your Bluetooth device, select Porsche Design PDH80.
2. Enter the headphone’ password “0000” (four zeros) if prompted. For those devices featuring Bluetooth 3.0 or higher, there is no need to enter a password.

Pair the headphone with another Bluetooth device
If you want to pair another Bluetooth device with the headphone, make sure the Bluetooth function on any other previously paired device is turned off. Then press and hold for five seconds. Release when ‘Pairing’ voice prompt is heard.

Note
The headphone stores four devices in the memory. If you try to pair more than four devices, the earliest paired device is replaced by the new one.

Use your headphone

Connect the headphone to your Bluetooth device

1. Turn on the Bluetooth function of your Bluetooth device.
2. Press and hold to turn the headphones on.
   • The blue LED flashes.
   • The headphone will search the last connected Bluetooth device and reconnect to it automatically. If the last connected device is not available, the headphone will enter pairing mode.

Tip
If you turn on the Bluetooth function of your Bluetooth device after turning on the headphone, you have to go to the Bluetooth menu of the device and connect the headphone to the device manually.

Note

• If the headphone fails to connect to any Bluetooth device within three minutes, they will turn off automatically to save the battery life.
• Some Bluetooth devices may not automatically find a connetiction. In this case, you have to go to the Bluetooth menu of your device and connect the headphone manually.

Wired connection
You can also use the headphones with the audio cable provided. Connect the supplied audio cable to the headphones and external audio device.

Multi-point connection

• Pairing
  • Pairing the headphones to two devices,
  • mobile phone and notebook.
• Switch between devices
  • Music can only be played from one device at a time. Your second device will be reserved for phone calls.
  • Pause the audio from one device to start playing audio from your other device.

Note

• Receiving a call on device two will pause playback on device one. The call will be routed automatically to your headphones.
• Ending the call will resume playback from device one automatically.

Control ANC (Active Noise Cancelation)

Enable ANC
Different ANC modes can be toggled by press ANC / Awareness mode button.

• ANC function is automatically activated when headphone is turned on.
• Press once ANC button, it will change to Ambient sound.
• Press once ANC button again. It will turn the ANC function off.

Tip
When connected to a Bluetooth device, removing the headphone will automatically activate sleep mode after three minutes. When you put the headphone back on your ears they will return to active mode. Power on/off Manage your calls and music

Call control voice assistant

LED indicator status

Battery LED indicator on Bluetooth device
A battery indicator will be shown on the screen when connected to headphone or another Bluetooth device, (refer to mobile phone’s operation manual).

Wearing Detection

• The music playback will be paused when take
  • ff the headphone from wearing.
• Then, the music playback will be resumed when you put on the headphone.

Note
If you do not wear the headphone for more than five minutes, the headphone will be powered off.

Technical data

• Music time: 80 hours (ANC off) |55 hours (ANC on)
• Talk time: 80 hours (ANC off) |55 hours (ANC on)
• Charging time: 2 hours rechargeable lithium polymer battery (800 mAh)
• Bluetooth version: 5.2
• Compatible Bluetooth profiles:
  • HFP (Hands-Free Profile)
  • A2DP (Advanced Audio Distribution Profile)
  • AVRCP (Audio Video Remote Control Profile)
• Frequency range: 2.402-2.480 GHz
• Transmitter power: < 13 dBm
• Operating range: Up to 10 meters(33 feet)
• Digital echo & noise reduction
• Auto power off
• Type -C-USB port for charging
• Supports ACC

Note
Specifications are subject to change without notice.

Notice

Declaration of conformity
Hereby, MMD Hong Kong Holding Limited declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU as well as UK Radio Equipment Regulations SI 2017 No.1206. You can find the Declaration of Conformity on www.porsche- design.com.

Disposal of your old product and   battery
Your product is designed and manufactured with high quality materials and components which can be recycled and reused.

This symbol on a product means that the product is covered by European Directive 2012/19/EU.
This symbol means that the product contains a built-in rechargeable battery covered by European Directive 2013/56/EU which cannot be disposed of with normal household waste. We strongly advise you to take your product to an fficial collection point or a Porsche Design service centre to have a professional remove the rechargeable battery. Inform yourself about the local separate collection system for electrical and electronic products and rechargeable batteries. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health.

Compliance with EMF
This product complies with all applicable standards and regulations regarding exposure to electromagnetic fields.

Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene(bags, protective foam sheet.)Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Notice of compliance
The device complies with the FCC rules, Part 15. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2.  This device must accept any interference received, including interference that may cause undesired operation.

FCC rules

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• . Increase the separation between equipment and receiver
• Connect the equipment to an outlet on a circuit different to that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Canada:
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

IC Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for uncontrolled environments.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Trademarks

Bluetooth
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MMD Hong Kong Holding Limited is under license. Other trademarks and trade names are those of their respective owners.

Siri
Siri is a trademark of Apple Inc., registered in the U.S. and other countries.

Google
Google and Google Play are trademarks of Google LLC.

Frequently asked questions

My Bluetooth headphone do not turn on.
The battery level is low. Charge the headphone.

I cannot pair my Bluetooth headphone with my Bluetooth device.
Bluetooth is disabled. Turn on your device and enable the Bluetooth feature before you turn on the headphone.

Pairing does not work.

• Turn off your headphone.
• Make sure you have disabled the Bluetooth function of any previously connected Bluetooth devices.
• On your Bluetooth device, delete “Porsche Design PDH80” from the Bluetooth list.
•  Pair your headphone (see ‘Pair the headphone with your Bluetooth device for the first time’ on page 6).

The Bluetooth device cannot find the headphone.

• The headphone may be connected to a previously paired device. Turn off the connected device or move it out of range.
• Pairing may have been reset or the headphone have been previously paired with another device. Pair the headphone with the Bluetooth device again as described in the user manual (see ‘Pair the headphone with your Bluetooth device for the first time’ on page 6).

My Bluetooth headphone are connected to a Bluetooth stereo-enabled mobile phone, but music only plays on the mobile phone speaker. Refer to the user manual of your mobile phone. Select to listen to music through the headphone.

The audio quality is poor and a crackling noise can be heard.

• The Bluetooth device is out of range. Reduce the distance between your headphone and Bluetooth device, or remove obstacles between them.
• Charge your headphone.

The audio quality is poor when streaming from a mobile phone, is very slow or streaming does not work at all.
Make sure your mobile phone not only supports (mono) HSP/HFP but also supports A2DP and is BT4.0x (or higher) compatible (see ‘Technical data’ on page 10).

References

• Porsche Design® Official Site | Porsche Design

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>