PORSCHE DESIGN PDS50 Wireless Speaker User Manual

PORSCHE DESIGN PDS50 Wireless Speaker User Manual

Safety

Important Safety Instructions

• Make sure that the power supply voltage corresponds to the voltage of the unit, there is a rating label on the back of the unit, it needs to open the net cover, the rating label  is located on the lower center of the plastic cover.
•  The speaker shall not be exposed to dripping or splashing.
• Do not place any source of danger on the speaker (e.g. liquid filled objects, lit candles).
• Make sure that there is enough free space around the speaker for  ventilation.
• Please use the speaker safely in an environment with temperature between 0° and 45°.
• Only use attachments and accessories specified by the manufacturer.

Battery safety precaution

• Danger of explosion if a battery is incorrectly replaced. Replace only with the same or equivalent type.
• A battery (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
• A battery in extreme high or low temperatures during use, storage or transportation, and low air pressure at high altitude can pose safety hazards.
• Do not replace a battery with an incorrect type that can defeat a safeguard (for example, some lithium battery types).
•  Disposing a battery into fire or a hot oven mechanically crushing or cutting a battery can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding, or an extremely low air pressure environment may result in an explosion or leakage of flammable liquid or gas.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation. Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Warning

• Never remove the casing of this speaker.
• Never lubricate any part of this speaker.
• Place this speaker on a flat, hard and stable surface.
•  Never place this speaker on other electrical equipment.
• Only use this speaker indoors. Keep this speaker away from water, moisture and liquid-filled objects.
• Keep this speaker away from direct sunlight, naked flames or heat.
• Risk of explosion if a battery is replaced by an incorrect type.

Notice
Hereby, TP Vision Europe B.V. declares that this speaker is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on www.porsche- design.com.
This speaker is designed and manufactured with high quality materials and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2012/19/EU.
Please be informed about the local separate collection system for electrical and electronic products.
Please act according to your local rules and do not dispose your old products with your normal household waste. Correct disposal of your old products will help prevent potential negative consequences for the environment and human health.
Your speaker contains batteries covered by the European Directive 2013/56/EU, which cannot be disposed with normal household waste. Please be informed about the local rules on separate collection of batteries because correct disposal will help prevent negative consequences for the environmental and human health.
This device contains licence exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.
The interference potential of the device could cause the interference to the system whose fundamental is 120 KHz to130 KHz.
This device complies with Part 18 of the FCC Rules. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Increase the separation between the equipment and any other radio device.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  The device prevent from using with damping environment. Use only in according with described instruction in order not to damange the device.

FCC Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 15 cm from all persons.

IC Radiation Exposure Statement

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 10 centimeters between the radiator and your body.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags and protective foam sheet).
Your speaker consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding disposal of packaging materials, exhausted batteries and old equipment.

Specifications

General information

Power requirement. …………………………………………………………………………………………………………………………………………………….5V 3A
Lithium battery……………………………………………………………………………………………………………………………………………..3.7V 7500mAh
Dimensions (W x H x D)…………………………………………………………………………………………………………………………..121 x 121 x 181 mm
Weight (Main Unit)…………………………………………………………………………………………………………………………………………………………..1.55kg

Amplifier

Output Power……………………………………………………………………………………………………………………………………………………………………….30W
Frequency Response…………………………………………………………………………………………………………………………………………..20 – 20000 Hz
Signal to Noise Ratio……………………………………………………………………………………………………………………………………………………….> 70 dB

Speakers

Speaker Impedance…………………………………………………………………………………………………………………………………………………………………3Ω
Speaker Maximum Input Power………………………………………………………………………………………………………………………………………….40W
Speaker Driver……………………………………………………………………………………………………………………………………………………………………..2.75″
Speaker Impedance…………………………………………………………………………………………………………………………………………………………………4Ω
Speaker Maximum Input Power…………………………………………………………………………………………………………………………………………….5W
Speaker Driver……………………………………………………………………………………………………………………………………………………………19x 19mm

Bluetooth

Bluetooth version…………………………………………………………………………………………………………………………………………………………………….5.0
Frequency range……………………………………………………………………………………………………………………………………………2402 – 2480 MHz
Maximum power transmitted……………………………………………………………………………………………………………………………………….8±2dBm
Maximum communication range…………………………………………………………………………………………………………………………..approx.
Compatible Bluetooth profiles………………………………………………………………………………………………………………………A2DP,AVRCP,HFP
Note : Design and specifications are subject to change without prior notice.

References

• Porsche Design® Official Site | Porsche Design

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>