MANTA CLK9020 Radio Clock with Bluetooth User Manual
- June 6, 2024
- MANTA
Table of Contents
MANTA CLK9020 Radio Clock with Bluetooth
SAFETY INSTRUCTIONS
WARNING
- Never remove the casing of the clock radio.
- Never lubricate any part of the clock radio.
- Never place this clock radio on top ofother electronic devices.
- Never expose the clock radio to sunlight, naked flames or heat.
- Make sure you have easy access to the power cord, plug, or adapter to disconnect the clock radio from the power.
- Read this manual
- Heed all warnings.
- Follow all instructions.
- Do not block any vents.
- Install the device in accordance with the manufacturer’s instructions.
- Do not install the device near any heat sources, such as radiators, warm air inlets, stoves and other appliances (including amplifiers) that produce heat.
- If a foreign object or a liquid accidentally gets inside the device, disconnect the power cord and have the device checked before re-use.
- Secure the power cord so that it cannot be walked on or pinched, particularly at plugs, convenience receptacles, and the point where the cord exits from the clock radio.
- Use only attachments and accessories specified by the manufacturer.
- Unplug the device from the power source during lightning storms and when not in use for long periods.
- Have the device repaired by qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power cord is damaged, liquid has been spilled on the apparatus, or an object has been dropped, exposed to rain or moisture, does not operate properly, or has been dropped.
- This clock radio shall not be exposed to dripping or splashing.
- Do not place potentially dangerous objects (eg, pots filled with liquids, lighted candles) on the clock radio.
- If the device is connected to a wall socket with the mains adapter, the plug must be easily accessible
PACKING LIST
Please make sure the purchased item is with the correct Model No. If the item model number doesn’t match with that of the package, please try to contact the agents.
OVERVIEW AND INSTRUCTION FOR USE
There will be a little temperature deviation since the temperature inductor is built-in.
- DCSVCharging slot
- LED
- USB USB slot
- Mic
- AuxAuxline-in
- TFTF card slot
LED indicator
Red light:be red when charging,be off when fully charged.
Blue light:blue light on after Bluetooth connected successfully /pause,blue
light flashing quickly when Bluetooth isn’t connected /FM channels auto
searching,blue light flash slowly when playing under Bluetooth/TF/FM/Aux mode.
Power saving
Screen brightness:the default brightness is brightest when turn on. Will go
back to be with darkest brightness after 20minutes.
Decoration light: be on when the speaker turn on,be off when the item in clock
mode(long press to turn it on/off) The speaker mode will be off automatically
after 2 hours with Bluetooth detached.
The speaker will be off automatically after 30 minutes of pause,underTF/AUX/FM
radio mode.
This speaker is with Bluetooth Speaker Mode and Alarm Setting Mode.
Bluetooth Mode : long press rotary knob to turn on,the speaker is in the
Bluetooth Speaker Mode at this status and Ala rm clock can’t be set.
Clock/Alarm Setting mode: long press rotary knob to turn off the speaker
and shit to clock/alarm mode while Bluetooth speaker is not functional.
Bluetooth Speaker Instruction:
This speaker is with Bluetooth Speaker Mode.
ong press IQ) button to turn on, the speaker is in the Bluetooth Speaker Mode
at this status.
The speaker mode will be off automatically after2 hours with Bluetooth
detached or without any operations.
How to connect the mobile phone by Bluetooth?
- Long press rotary knob button for 3 seconds to turn on the speaker,and Blue LED indicator will flash
- Turn on the Bluetooth from the mobile phone and search KS, and then match the speaker to the mobile phone. There will be a prompt sound after connection succeeded. (Note: There is a memory function for the Bluetooth speaker. Turn off the Bluetooth of the previous mobile phone before connecting the speaker to another one).
- Hands-free function: Short press the button to answer the phone call, long press the rotary knob button to refuse the phone call. Press this button to finish the phone call.
How to Line-in by Aux(external audio input)?
This speaker can connect to all kinds of audio devices (such as mobile phones,
pad, MP3 player, cassette player, CD player, radio, etc.). with 3.5mm AUX plug
in the earphone jack of the audio device and the other end in the AUX slot of
the speaker, then press”M”button to get into Aux Mode.
How to use MicroSD/TFCard/USB Disk?
Insert the Micro SD/TF Card into the TF slot of speaker, there will be a
prompt sound, and then play the audio files from the card, when the unit is
undertheTF card mode.
Insert USB Disk into USB slot of speaker, there will be a prompt sound, and
then play the audio files from the USB Disk. It supports following the
following format file: MP3, WAV.
It supports maximum 32GBTF card.
How to use FM radio?
Press”M” button to shift into FM mode, and insert the antenna to 3.5mm Aux
slot.
Long press “M” button and the speaker will get into FM channels searching mode
automatically. When the led indicator will bean and blue,will flash quickly.
The speaker will save and play FM channels after the searching is done. (The
radio effect depends on the circumstances and signal. Radio will be good and
with strong signal when there is less Interference, will not be good and with
weakslgnal when there Is much Interference).
How to charge?
- The speaker will make a prompt sound and turn off automatically when the battery is low. Insert one end of the cable into the charging slot of the speaker, and the USB plug into the computer or the mobile charger (5V 2A). The front indicator light on red indicates it’s charging; the front indicator light off indicates it’s fully charged. (If the charging voltage is over 5V, the speaker’s internal chip will be burned out).
- lt takes around 3/4 hours for the speaker to be fully charged. It could work about 5/8 hours at maximum volume.
Reset function:
When the buttons are out of control, the speaker may get stuck. Please check
if the battery ran out. If the battery ran out, please charge it. If the stuck
happens while the battery is full, please take the sharp object to
insert”Reset”jack about 5/10 seconds to reset.
Using the speaker with tablet, PC/Notebook:
Connect the speaker and tablet, PC/Notebook by using the 3.5mm AUX cable.
Time/ClockAlarm Setting Instruction
Time setting(year/month/date)
Short press rotary knob under clock mode,the numbers will flash after a
reminder sound”time setting press © 0 in turn to set hours/minutes and
year/month/date.Rotate the knob to choose the objects which need to be
adjusted.
Alarm 1 setting: Press 0 button after time setting finished, the screen will display AL 1 and display•o9:00 rotate the knob to choose the alarm time.
Alarm On/Off: press 0 button after alarm setting finished,the screen will
display”OFF”and there is a reminder sound “alarm one off”. Rotate the knob,the
screen will display”ON”and there is a reminder sound”alarm one on
Shortcut button for alarm On/Off: Short press© Q) could turn on or turn off
the alarm 1 and alarm 2 in turn. There is no e e icon when the alarm is off.
Rings choice: there are S built-in rings available and TF card audio
source also could be used as alarm rings.The TF card has to be put into the
speaker and there are audio sources in the TF card.The rings will play the
audio files in turns as the speaker works in TF card mode. The alarm will play
the first built-in ring if there is no card in the speaker.even if TF card has
been set as the ring sources for alarm 1.
Press get into the alarm 2 setting,the setting way is the same as the alarm 2.
Press Q) the rotary knob to save all the settings.
Snooze Press: to end the alarm ring when it starts. press any other buttons to get into snooze status. The alarm will ring 5 minutes, 1 0minutes interval each time in snooze status.The ring lasts about 1 minute each time.
F&Q
- lt cannot be matched with the devices by Bluetooth: (1) turn off the speaker and mobile phone, and then turn on both. Rematch. (2) If there are too many Bluetooth devices around, turn off the other Bluetooth devices in order to connect to one device.
- Sound is too small or distortion is too much: (1) Maybe the battery runs out. Please charge it. (2)Turn up the volume of the mobile phone.
- Sound goes off and on: please check if the range between the speaker and the device is more than 1 0 meters. Or check if there are any barriers between the speaker and the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>