FOXTECH H-Wing GPS WiFi Fixed Wing VTOL with 720p HD Camera User Guide

June 6, 2024
FOXTECH

FOXTECH H-Wing GPS WiFi Fixed Wing VTOL with 720p HD Camera User Guide
FOXTECH H-Wing GPS WiFi Fixed Wing VTOL with 720p HD
Camera

Charging the Battery

Please connect your charger with a type-C data cable to charge the remote control.

Assemble the drone

Assemble the drone
Assemble the drone

Attaching the Propellers

Attaching the Propellers

Open and close the remote control, Install the battery

Open and close the remote control, Install the battery

Remote Controller

Remote Controller

Controlling the drone

Controlling the drone

Enter position mode

In an open outdoor environment, move the remote control to the left and wait for the aircraft to enter the position mode.
Enter position mode

How to unlock(US hand)

After entering the position mode, the throttle stick is the lowest and the heading stick is the rightmost to unlock the aircraft. After the motor rotates, please release the joystick immediately.

Rotor switch fixed wing mode

Rotor switch fixed wing mode
Rotor switch fixed wing mode

How to lock (US hands)

After the aircraft lands on flat ground, hit the throttle stick to the lowest position and hold it for a few seconds before the motor stops.
How to lock

Disconnect the power

Disconnect the power

FCC Warning

Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Information to user.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be operated with minimum distance 20cm from the body.

IC Warning

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

  1. This device may not cause interference;
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment should be operated with minimum distance 20cm from the body. CE Warning

  1. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
  2. The operating temperature of the device can’t exceed 40℃ and shouldn’t be lower than -20℃.
  3. The device complies with RF specifications when the device used at 20cm from the body. Hereby, Shenzhen HEQ Intelligent Technology Co. LTD. declares that this product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals