FOXTECH EH30-M TIR Dual Sensor 30X Optical Zoom Camera User Manual
- June 3, 2024
- FOXTECH
Table of Contents
FOXTECH EH30-M TIR Dual Sensor 30X Optical Zoom Camera
Note
Disclaimer
Thank you for purchasing this product. This is a special web page for gimbal
and cameras, you can enter this page for the latest product information,
technical support and user manuals. https://www.foxtechfpv.com/industrial-
drone/camera-for-drones.html We recommend that you download and use the
latest user manual. And no further update notice will be given separately. Due
to different production batches, the appearance or function parameters are
slightly different, which does not affect the normal use of the product.
Please read this statement carefully before use. Once used, it is deemed to be
an endorsement and acceptance of the entire contents of this statement. Please
read the instruction manual carefully and strictly follow the requirements of
this manual to install and use this product. Foxtech will not bear any legal
responsibility for any results or losses caused by improper use, installation,
final assembly and modification by users.
Intellectual Property Rights
The intellectual property rights of this product and manual are owned by
Foxtech Trade Co., Ltd. Without written permission, no organization or
individual may copy, reproduce or distribute in any form. If quotation is
needed, the source must be indicated, and this manual must not be modified,
deleted or quoted against its original intention.
System Composition
Product System Atlas
Installation and setup methods
of third-party videolink
A. Modify IP of Pod and IDU (segment to meet videolink requirements) Pod
segment modification, take “change 42 segment to 1 segment” as an example:
-
pod electrified, and connected the pod to the computer through the wire, the pod works normally after about 15 seconds, the computer recognizes the camera network.
-
TCPIPV4 settings, as shown below, are saved after confirmation
-
Use GCS ground station for gateway setting Click to search device, then double-click the pop-up IP bar, save it after modification, and restart the gimbal.
-
Camera IP modification Open any browser, enter 192.168.42.108 After entering the following interface, username, password are admin Confirmation Then the following password modification interface appears, click cancel Do not modify the password, otherwise the software will not working properly.
After entering the setup interface, click Settings Network Settings General Settings Change the IP address and default gateway “42” to “1”, then click Save.
-
Pod net segment setup complete. Change the network segment settings in the computer TCPIPV4 to the normal network segment.
GCS Software Usage Instructions
Operating Pods
gcs support remote real-time download of camera side video, photos.
- Operational steps view download interface (as shown below) can download video (MP4 style), photo (jpg) offline. And the photos support real-time preview.
Frequently Asked Questions
No Image
Hardware checking:
pod power supply is normal, pod and idu module are properly connected. The pod
works properly. Datalink (sky end, ground end) power supply is normal. The
datalink sky end is properly connected to the IDU module, and the connection
wire is not broken. The datalink ground end and the computer is connected
normally, the network wire does not have the damage to break the circuit.
Software setup check:
Make sure the computer network is set correctly and the computer turns off the
wifi when connecting the datalink. The computer is not connected to any
network other than the data link. Software network IP address is incorrect
:(when the gimbal, and camera IP address changes, need to synchronously modify
this software IP) Open GCS software network settings Modify the IP address
.
This content is subject to change. Download the latest version from
https://www.foxtechfpv.com/eh30-m-tir-gimbal-camera.html For everyday
updates, please follow Foxtech facebook page”Foxtechhobby”. YouTube Channel:
Foxtech
©2020 FOXTECH All Rights Reserved 14
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>