OLIGHT Warrior Mini 2 Brass Rechargeable LED Flashlight User Manual

User Manual

WARRIOR Mini2 Brass
(LIMITED EDITION:

Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

SPECIFICATIONS

• All above specifications are test results based on ANNINEMA ELI-2009 Standard. The tests are performed using the battery included in the flashlight.

TEAR HERE TO TAKE OUT THE PRODUCT AND DEOXIDIZER.

BATTERY INSTALLATION

Before first use, please unscrew the body and remove the insulating film. If the battery needs to be replaced, make sure that the positive end of the new battery faces the flashlight head when you put it in.

AVAILABLE BATTERIES

• 1 x customized 3500milh 18650 rechargeable lithium battery

BATTERIES LEVEL INDICATOR

NOTE: If using moonlight mode, the battery indicator will only display when the battery level is below 5%.
USB MAGNETIC CHARGING CABLE — MCC3

sinstrficiEnttopravdo 5V 13A tow capacity. lie &inn? tine will be longer)
Charge indication| Red: charging Green: full (over 95%) or disconnected with a flashlight

CHARGING

• Before the first use please fully charge the product.
• Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a 7.5W (5V 1.5A) USB power source). The red indicator means charging, while the green indicator means charging completed (battery level >95%). * Only charge with standard MCC3, not compatible with other MCC.
  PROXIMITY PROTECTION FUNCTION
  When the front lens proximity sensor detects an obstruction nearby, the brightness will automatically reduce. While in this state, the side switch can only turn the light off. The light will turn off directly if the blockage continues for more than 60 seconds.

ATTENTION

1. Please keep the surface of the lens clean. Stains or water mist will affect the performance of the built-in sensor located in the black area, resulting in the failure of high and above modes, please erase in time.
2. Pay attention to protecting the lens from scratches. Scratches on the surface of the lens will reduce the luminous flux. In severe cases, it will affect the internal sensor performance, resulting in the failure of high and above modes.

DANGER

• DO NOT throw the light directly into human eyes. This may cause temporary blindness or permanent damage to the eyes.
• The max load of the Carabiner-Style Ring is 5kg, and please DO NOT use it for climbing.

WARNING

• DO NOT activate turbo mode repeatedly under high temperature to prevent the flashlight body from overheating and hurting the user’s hand.
• The tail switch may not work while immersed in seawater or other conductive media. Please try to keep it clean and dry.
• DO NOT use non-protected rechargeable batteries.
• DO NOT use the battery if the wrapper is broken, or in any other compromised state.
• 00 NOT take the battery out of the flashlight for charging.
• DO NOT clean the lens with alcohol or any other chemicals.
• Take good care of the battery; if the battery needs to be replaced, please keep the removed battery in a safe place. DO NOT mix it with the conductive metals.
• If the product is left unused or carried and transported, please lock the button to avoid accidentally activating the flashlight.

NOTICE

• When the flashlight is turned off, moonlight, low, medium, or high mode will be memorized and become the default mode when the light is turned on again (high mode will only be memorized for 10 minutes. After that, the memorized mode will revert to the medium setting).
• The turbo mode will slowly step down to high mode in 4 minutes at normal temperature.
• DO NOT short-circuit the tail switch cap with the surrounding ring. A short circuit in this case will result in a weak electric discharge between them and may lead to a complete battery drain if it is in this state for too long.
• The magnetic tail is easy to attract iron debris. Please keep the tail switch cap and the ring surrounding it clean.
• NOTICE: The lanyard clip can only be installed in the rear clip slot as shown below.

EXCLUSION CLAUSE

Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual, including but not limited to using the product Inconsistent with the recommended lockout mode.

HOW TO OPERATE

SIDE SWITCH
ON/OFF: Single-click the side switch to turn the light ON/OFF. When the light is turned on again, it returns to the previously memorized mode.
CHANGE BRIGHTNESS LEVEL : When the flashlight is on, press and hold the side switch and it will, staffing from the present brightness level, automatically cycle through Low, Medium, and High mode. The mode is selected when the side switch has been released. ( Please note: moonlight and turbo are not in the automatic cycle ). MOONLIGHT MODE: When the flashlight is off, press and hold the side switch for over one second to access the moonlight mode lithe memorized mode is moonlight, simply click the switch to access it.
TURBO AND RETURN: fast double click on the side switch to enter into Turbo, double click again to return. If memory mode were High or Medium; the output is Medium; if memory mode were Low or Moonlight, the output is memory mode.
STROBE: Quickly triple-click the side switch to enter the strobe mode. To quit this mode, single click or press and hold the side switch.
LOCKOUT/UNLOCK: When the flashlight is off, press and hold the side switch ( for about 2 seconds ) to access the button lockout mode ( the flashlight will enter the moonlight mode first and will then switch off to signal the lockout mode ). Under the lockout mode, press and hold the side switch for less than one second. The red indicator below the side switch will be on for two seconds to signal that the light is still in lockout mode. To unlock it, keep holding the side switch for over one second until the moonlight mode is on again.
TAIL SWITCH
The flashlight produces different output settings by pressing lightly or hard on the tail switch (please refer to the following program configurations).
TWO DIFFERENT PROGRAM CONFIGURATIONS CONFIGURATION 1 (FACTORY DEFAULT SETTING):
Half-press for Medium, hard press for Turbo; Single press the tail switch (press and release quickly) to turn the flashlight on or off; Press and hold the tail switch for momentary-on. Release to turn off.
CONFIGURATION2: Half-press for Turbo. hard press for Strobe, release switch to turn the flashlight off.
SWITCH BETWEEN DIFFERENT PROGRAM CONFIGURATIONS
Switch between configuration 1 and configuration 2 by pressing hard then holding the tail switch and single press on the side switch at the same time; when you release the tail switch, the Configuration will be selected.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one-year warranty for all rechargeable batteries. MCC magnetic USB charging cable: One year. For any of the fragile or low-value fittings not covered above, like lanyard and clip, you can contact the post-sale in 30 days after the purchase, if it has any quality drawback or damage under normal use conditions. If such drawback or damage occurs 30 days after the purchase or under abnormal use conditions, we will only offer conditional quality assurance as appropriate.

USA Customer Support
cs@olightstore.com
Global Customer Support
Customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.

EU-DECLARATION OF CONFORMITY

EU-Declaration of Conformity can be found hem:
https://olightworld.com/ec-declaration

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park,
No 6 Zhongnan Road. Changan Town,
Dongguan City, Guangdong, China.
Made in China
www.Drmemory.com/ollght
27, 12, 2021 3.0334.6010.9007

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>