D-Link DIS-100G-8W Industrial Unmanaged Switch Installation Guide

June 6, 2024
D-Link

D-Link DIS-100G-8W Industrial Unmanaged

Quick Installation Guide

Package Contents

Open the shipping carton of the switch and carefully unpack its contents. The carton DIS-100G-8W switch

  • DC power terminal block
  • Wall mounting kit
  • DIN-Rail mounting kit
  • Quick Installation Guide should contain the following items:

Hardware Overview

Interfaces

Interface Description
Ports 1-8 1000Base-T ports

LED Indicators

LED Status Description
ALM On red Power failure alarm occurs.
Off No power failure alarm.
P1 On green P1 power line has power.
Off P1 power line is disconnected or does not have a power supply.
P2 On green P2 power line has power.
Off P2 power line is disconnected or does not have a power supply.
Link/Act (Ports 1-8) On green Ethernet link is up.
Blinking green Ethernet link is up and there is traffic detected.
Off Ethernet link is down.
Speed (Ports 1-8) On yellow 1000 Mbps connection is detected.
Off No link or 10/100 Mbps connection is detected.

DIP Switches

Pin № State Description
Pin 1 ON To enable broadcast storm rate limit.
OFF To disable the broadcast storm rate limit.
Pin 2 ON To enable the power alarm.
OFF To disable the power alarm.

Hardware Installation

DIN Rail Mounting

Mounting steps:

  1. Screw the DIN-Rail bracket on with the bracket and screws in the accessory kit.
  2. Hook the unit over the DIN-Rail.
  3. Push the bottom of the unit towards the DIN-Rail until it snaps into place

Wall Mounting

Screw on the wall-mount plate with the plate and M4 screws in the accessory kit.

D-Link DIS-100G-8W-Industrial-Unmanaged-Switch-fig3

D-Link DIS-100G-8W-Industrial-Unmanaged-Switch-fig4

Grounding the Switch

Use the following instructions to ground the switch. Please complete these steps before powering on the switch.

  1. Remove the grounding screw from the switch and place the grounding cable lug ring on top of the grounding screw opening. Insert the grounding screw back into the
  2. grounding screw opening and use a screwdriver to tighten the grounding screw, securing the grounding cable to the switch.
  3. Attach the terminal lug ring at the other end of the grounding cable to an appropriate grounding source.
  4. Verify that the connection between the grounding connector on the switch and the grounding source is secure.

Connecting to a Power Source

The switch can be powered by two power supplies (input range 12 to 58 V DC). Insert the positive and negative wires (AWG 14-26) into V+ and V- contact on the terminal block and tighten the wire-clamp screws to prevent the wires from being loosened.

Alarm Relay Connecting

The alarm relay output contacts are in the middle of the DC terminal block connector shown in the figure below. By inserting the wires and setting the DIP switch of the respective Port Alarm to “ON”, the relay output alarm will detect any port failures, and form a short circuit. The alarm relay out is “Normal Open”.

D-Link DIS-100G-8W-Industrial-Unmanaged-Switch-fig6

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals