ICOM HM-169IS Water Proof Speaker Microphone Instructions
- June 6, 2024
- ICOM
Table of Contents
ICOM HM-169IS Water Proof Speaker
**Microphone Instructions**
Thank you for purchasing the HM-169IS waterproof speaker microphone.
Please read these instructions and transceiver’s instruction manual carefully
before installation and operation.
Versions of the HM-169 which display the “HM169IS” model name on the serial number label, conform to intrinsically safe ratings of the FM approvals.
The repair and maintenance of an FM approved equipment can only be performed
in an Factory Mutual approved repair facility.
The FM approval will be cancelled if FM intrinsically safe equipment is
repaired anywhere except in an approved facility.
FOREWORD
- The microphone has outstanding protection against dust and water that is rated IP57. The microphone can withstand submersion in 3 ft (1 m) depth of water for up to 30 minutes and has a dust-tight construction that prevents the ingress of dust.
- Improved speaker audio quality and loudness.
PRECAUTIONS
CAUTION : Attach the speaker microphone’s connector securely to prevent accidental detaching from the transceiver, or water intrusion into the connector. (See the transceiver’s instruction manual for installation details.)
BE SURE to turn OFF the transceiver’s power when attaching or detaching the microphone. Otherwise a malfunction may occur, or may damage to the transceiver or microphone.
NEVER immerse the connector in water. If the connector becomes wet, be sure to dry it BEFORE attaching it to the transceiver.
DO NOT use or place the microphone in areas with temperatures below –4˚F (–20°C) or above +104˚F (+40°C).
DO NOT use harsh solvents such as benzine or alcohol when cleaning, as they can damage the microphone’s surfaces.
BE CAREFUL! The microphone meets IPX7 requirements for waterproof protection. However, once the microphone has been dropped, waterproof protection cannot be guaranteed because of possible damage to the microphone’s case or the waterproof seal.
DO NOT modify the microphone for any reason. Repairs should be done at an authorized Icom service center only. Waterproofing cannot be guaranteed if you open the microphone yourself, or have it done at a non-authorized dealer/service center.
USE specified Icom transceivers only. Other manufacturer’s transceivers have different pin assignments and damage may occur to the transceiver or microphone, if attached.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries.
PANEL DESCRIPTION
NOTE : The microphone is located as shown above. To maximize the readability of your transmitted signal (voice), hold the microphone approx. 2 to 4 inches (5 to 10 cm) from your mouth, and speak at a normal voice level.
DETACHING/ATTACHING THE BELT CLIP
To detach the belt clip:
- Lift up on the tab (1).
- Then slide the belt clip in the direction of the arrow (2).
To attach the belt clip:
Slide the belt clip in the direction of the arrow (1) until the belt clip locks in place and makes a ‘click’ sound.
SPECIFICATIONS
Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
American Communication Systems
Discover the power of communications TM
http://www.ameradio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>