mestic MCC-25 AC-DC 1502930 Cool Box Compressor Instructions

mestic MCC-25 AC-DC 1502930 Cool Box Compressor

Introduction

 |
---|---
Product name| Cool box
Item number| MAC 40
Net volume| 42 L
Climate Classification| SN, N
Insulation class| I
Refrigerant| NH3 (80 g), H2O, He
Foam vesicant| C-Pentane
Net weight| 18.5 kg
Mains voltage| 220-240~50Hz
Rated current (AC)| 0.36A
Rated power (AC)| 82W
Consumption of energy (AC)| 1.2 kWh/24h
Battery voltage| 12V
Rated current (DC)| 6.25A
Rated power (DC)| 75W
Consumption of energy (DC)| 150 Ah/24h
Appliance category & Gas pressure| ****
Total heat input| 0.18 kW (12.8 g/h)
Injector size| 0.23 mm
Rated gas power| 0.18 kW
Minimum gas power| 0.12 kW
Maximum gas consumption| 12.8 g/h
Minimum gas consumption| 8.3 g/h
Order number| INK-026179 a1 b1
Made in China PIN: 0359DL05716

For all appliances: Read manufacturer’s instructions before use this appliance shall be installed according to the rules in force;
For type A11 appliances: To be used only in a well-ventilated area, above ground and protected from rain.

Safety regulations

• Read the manual before use. Keep the manual and sales receipt for later reference if needed.
• If the conditions of use are not adhered to, the manufacturer will not be liable for any damage or injury resulting from the use of this
• Device.
• Children under 8 years old should not use this device. Children aged 8 years and older should only use the device if they are supervised by an adult.
• The appliance must always be on a flat, stable and dry surface.
• Never use the appliance if there is damage or breaks in the cord.
• Never attempt to repair the device yourself if the appliance, the cord or the plug is damaged. Always have this done by the manufacturer or a qualified technician.
• Always use and store the device in a dry place.
• Check if the voltage indicated on the appliance corresponds to the mains voltage connection.
• Never use accessories that are not recommended by the manufacturer.
• Never pull the cord to disconnect the plug from the power supply.
• Always remove the plug from the power supply when the device is not in use or when you have no view of the device.
• Always remove the plug from the power supply if it is to be serviced or cleaned.
• Never use the appliance near hot or warm objects (direct heat sources).
• Do not allow the device to come into contact with rain.
• Do not place other electrical appliances in the appliance.
• Do not place any chemical or explosive agents in the device.
• This appliance is only suitable for household use.
• When using AC power, use a grounded AC outlet.
• Only use the DC 12V or the 230V connection cable. NOTE: Never use both energy sources at the same time.
• Before cleaning, remove the products from the appliance and unplug the power supply. Clean only with a slightly damp cloth, if necessary a non-aggressive cleaning agent can be used. After cleaning, always dry all wet surfaces with a dry cloth.
• Never use sharp or abrasive products to clean the device.
• Precautions should be taken to comply with national regulations regarding the use of gas appliances while the vehicle is moving.
• Important advice for good use: due to the energy policy, this cool box should mainly be used in gas mode.
• Defrost the appliance regularly to ensure that the appliance functions optimally

For use

• Remove all packaging materials from the device.
• Place the device on a flat and stable surface with at least 10cm free space on each side.
• Wipe the inside of the appliance with a warm and slightly damp cloth.
• To ensure good air circulation, do not block the ventilation grilles on the top, bottom and back of the appliance.
• When operating on a boat, make sure that the power supply is equipped with an earth leakage circuit breaker.
• Please review the above terms of use before use.

Operation on power (12v or 220-240v)

• Never use different energy sources at the same time.
• Check whether the mains voltage corresponds to the operating voltage displayed on the device.
• If the electrical specifications are correct, plug the electrical safety plug into a grounded electrical outlet.
• Turn thermostat to “MAX”. The cooling process only becomes apparent after about an hour (icing on evaporator).
• Then set the thermostat to the desired position.
• Turn the thermostat to 0 to switch the appliance off. The plug can then be removed from the power supply

Operation on gas

• Never use different energy sources at the same time.
• Familiarize yourself with the appliance before connecting it to the gas cylinder.
• When operating on gas, the cool box may only be used outdoors and in well-ventilated areas. Operation of the gas cooler is prohibited in road vehicles, on boats and in closed areas.
• The appliance must be in the open air (but not in the rain) when used with gas. This means that it can also be used under the canopy of a tent, adequately ventilated, or on a terrace in an apartment and a garden.
• The recommended gas supply pressure is stated on the device in mbar. The device does not operate at any other pressure.

Storage of gas cylinder

• Store the gas cylinder in a cool, dry and ventilated area, protected from sunlight. The gas cylinder must not be exposed to temperatures higher than 50 degrees.

Connection of the cool box to the gas cylinder

• Warning: Always stay away from any kind of ignition during this action. Do not smoke.
• Connect the cool box in the following way: Gas cylinder> pressure regulator> appliance
• The cool box works on propane / butane gas G30.G31 and is suitable for connection with a propane hose that conforms to EN559 or EN1763. Connect the gas hose to the connecting piece of the appliance using a screw connection. It is important to follow the installation and connection instructions to connect the appliance. Avoid twisting and bending the hose. Bends in the gas hose must have a radius of more than 40 mm. The length of the hose should not exceed 1.50m. Before installation, check that the operating pressure of the gas pressure regulator corresponds to the operating pressure of the appliance.
• Use soap water or gas leak spray to check connections for leaks. It is forbidden to check for leaks with a flame.
• Do not smoke: risk of explosion and burns.
• If you change the gas bottle and / or disconnect the hose, it is mandatory to close the gas bottle valve.
• Replace the hose if it is damaged or becomes porous and always before the expiration date printed on the side.

Throttle position

• This arrangement includes an adjustable appliance with an enclosed protection and a burner with an electric igniter.
• The adjustable device can be set in 3 different positions:
• Max Maximum cooling
• Min Minimum cooling
• 0 off Ignition position / burner gas supply closed
• The protection automatically maintains the gas supply to the burner as long as it burns. It automatically turns off the supply when the flame goes out.

Operation of the gas cooler

• Open the valve of the gas cylinder. Press and hold the adjust button. Then turn the knob counterclockwise to Max.
• If the appliance has not been lit for a long time or if the gas cylinder has been changed, there may be air in the pipe. Therefore, the Ignition may fail. Check if the pilot is lit by looking through the hole at the top of the aircraft. If the appliance does not light up, try again after 10 seconds.
• Always set the thermostat to “MAX” for the first hour. Then set the thermostat to the desired position.
• If the outside temperature is low, set the adjustable appliance to MIN after a sufficiently long cooling down period in MAX period.
• Turn the thermostat to 0 and shut off the gas cylinder or the pressure regulator to switch off the appliance.

Maintenance

• For optimal use, the cool box must be defrosted regularly. Unplug it and remove all food. If necessary, use a cloth with warm water.
  After defrosting, absorb all water with a dry cloth and clean the inside. Are you not using the device for a long time? Then leave the lid slightly open to avoid an unpleasant odor.

• Clean the device regularly with warm water, if necessary with a cleaning agent.

• Never use a corrosive product. Dry the cleaned surfaces with a soft cloth.

• All repairs, especially those of the cooling unit or the gas burner system, must be carried out by a qualified technician.

Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means that this product must be handled pursuant to European Directive (2012/19/EU) in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional authorities. Electronic products not included in the selective sorting process are potentially dangerous for the environment and human heath due to the presence of hazardous substances.

Declaration of conformity

Hereby, Gimeg Nederland B.V., declares that the MAC-40 device complies with the basic requirements and other relevant regulations specified in the European Electromagnetic Compatibility Directive (EMC 2014/30 / EU) and Low Voltage Directive (LVD 2014/35 / EU) and guidelines for appliances that burn gaseous fuels (GAR EU 2016/426)
You can request a full declaration of conformity from the address shown on the back.

Importer:
Gimeg Nederland B.V.
Strijkviertel 27
3454 PH De Meern
The Netherlands

Documents / Resources

| mestic MCC-25 AC-DC 1502930 Cool Box Compressor [pdf] Instructions
MCC-25 AC-DC 1502930 Cool Box Compressor, MCC-25 AC-DC, 1502930 Cool Box Compressor, Box Compressor
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>