bewello BW2032 Light Therapy Aroma Diffuser User Manual
- June 6, 2024
- bewello
Table of Contents
bewello BW2032 Light Therapy Aroma Diffuser
Light therapy aroma diffuser
THINGS TO DO BEFORE FIRST USE
- Check that the device is not damaged in its packaging.
- Make sure the device and all of its accesories are in the packaging.
USER MANUAL
- Hold the bottom of the device with one hand and the top with the other hand and remove the outer cover. Then remove the top of the water tank so you can easily fill it with water.
- Fill the product water tank with a little water. Attention! Do not overfill the maximum mark, as this may damage the device! The device filled with water must not be tilted or rotated on its side. If you wish, you can use a few drops of essential oil.
- Assemble the appliance: Place the top of the container on the bottom of the container and place the outer cover on it.
- Connect the USB connector to a suitable AC adapter or USB socket with the correct voltage level and current. The device is now in standby mode.
- Use the button on the bottom of the appliance to switch on the humidifier. When you turn on the humidifier, you may have to wait up to 1 minute to humidify (depending on how long you have used the device). After pressing the LED button on the left next to the power button, the LED light can be switched on or off as required. The button on the right side of the power button allows you to schedule humidification so that the device can be switched off automatically after 1-3-6 hours.
WARNINGS!
- Only connect to a USB socket that corresponds to the voltage level of the device!
- Do not operate the appliance with wet hands!
- Please keep the appliance out of the reach of children!
- The appliance may only be used by children with parental supervision!
- Do not touch the carburetor with a sharp, hard object. Avoid damaging the surface, use only a soft cloth to clean the device.
- If you do not use the appliance for a long time, please unplug the power cord from the USB socket and pour out the water in the tank!
- If you notice damage to the appliance or the cable, please do not use the appliance! In case of a faulty cable, please replace it with a factory cable!
- Clean the water tank regularly to prolong the life of the appliance.
- Operating the device without water can lead to serious damage to the device! The amount of evaporated water must be replaced during use! We recommend using tap water!
- Do not use too high a concentration of essential oil! Such essential oils are usually stored in a bottle and cannot be placed in a plastic container. The high concentration of oils placed in the humidifier degrades the evaporation performance and makes the water tank of the appliance difficult to clean. The manufacturer and distributor are not liable for any damage resulting from the use of poor quality, density essential oil!
- Use water-soluble essential oils: products obtained by dissolving 40 to 60% in ethanol (or other water-soluble solvents such as propanol, propylene glycol, glycerol, etc.). These essential oils are compatible with the humidifier and can be used with the device.
- If you also use essential oil, the appliance must be cleaned after each use! Do not use chemicals during cleaning!
- Use the device only for its intended purpose! Please keep this manual for future reference or attach it when you lend it!
MALFUNCTIONS
Humidification does not start after switching on.| It may take up to 1 minute
before you start humidifying for the first time – or if you havent used it for
a long time.| Make sure the cable is securely connected to the USB port.
---|---|---
Humidification stagnates, not continuous.| Not enough water in the container|
Please check the amount of water in the tank and refill if necessary.
The atomizer plate is dirty| Please clean the atomizer plate in the middle of
the tank with a soft cloth.
The top of the appliance accidentally came into contact with water.| | Please
de-energize the device. Place in a safe place for at least 24-48 hours to
allow it to dry. (Do not use radiators, hair dryers or other heat sources)
Have the appliance checked by a specialist before putting it into operation!
TECHNICAL SPECIFICATIONS
Energy source: DC 5V, 1A
Connector type: USB
Water tank volume: 160 ml
Suggested area: Max 13 – 15 m²
Evaporation: 25-30 ml / h
Operating time (with one charge): about 3-5 hours
Dimensions: 100 x Ø140 mm
Cable length: 100 cm
Color: Black
Material: Plastic
Package contents: 1 evaporator 1 USB cable
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>