Ferono FK90E3 Air Curtain with an Electric Heater User Manual
- June 6, 2024
- Ferono
Table of Contents
Ferono FK90E3 Air Curtain with an Electric Heater User Manual
www.ferono.com
info@ferono.com
Thanks for purchasing this Air Curtain, Please read these instructions carefully before use.
1 PRODUCT INTRODUCTION
As one of the new top-class products for modern decoration, air curtain is also matched with the air conditioner. And it is installed at the entrances of supermarket, theater, meeting room, hotel, office room, working shop and storeroom to prevent the dust, mosquito and nocuous air, and so on.
2 MODEL INTRODUCTION
3 IDENTIFICATION & INSTALLATION DIMENSIONS
4 INSTALLATION CAUTION
Must follow the following requests when installing air curtain:
5 INSTALLATION
- A Installing on the concrete wall:
- B Installing on the wooden wall:
- C Hanging from the ceiling
6 HEATING MODEL TECHNICAL PARAMETER
7 OPERATION
7.1. Controlled by remote controller
-
a. Press “ON/OFF” button to turn ON the unit. Main receiver receives the signal with the sound of “beep” to start working with the green light in cool mode at high speed “H”. Press “ON/OFF” button again to turn OFF.
-
b. When the unit is working at the above a. situation, press “COOL” button in the Remote controller, receiver receives the signal with the sound of “beep” and switch high speed to low speed “L”. Meanwhile there is a green light display in the receiver. Press “COOL” button again, the unit will switch low speed to high speed. So when the unit is working at cool mode, press “COOL” button can switch air curtain working under the cycle of Low or High speed.
-
c. FOR SINGLE PHASE UNIT: When the unit is working at the above b. situation, press “HEAT” in the remote controller, receiver receives the signal with the sound of “beep” and switch cool mode to heating mode at low power. Meanwhile there is a Red light display in the receiver. Press “HEAT” button again, the unit will switch low power to high power. Meanwhile there is TWO Red lights display in the receiver. Press “HEAT” button again, the unit will switch heating mode to cool mode and the red lights display change to green light in the receiver. So when the unit is working at cool mode, press “HEAT” button can switch air curtain working under the cycle of heating low power, heating high power or cool mode.
FOR THREE PHASES UNIT: When the unit is working at the above b. situation, press “HEAT” in the remote controller, receiver receives the signal with the sound of “beep” and switch cool mode to heating mode at low power. Meanwhile there is a Red light display in the receiver. Press “HEAT” button again, the unit will switch low power to middle power. Meanwhile there is TWO Red lights display in the receiver. Press “HEAT” button again, the unit will switch middle power to high power. Meanwhile there is THREE Red lights display in the receiver. Press “HEAT” button again, the unit will switch heating mode to cool mode and the red lights display change to green light in the receiver. So FOR THREE PHASES MODEL when the unit is working at cool mode, press “HEAT” button can switch air curtain working under the cycle of heating low power, heating middle power, heating high power or cool mode. -
d. When the unit works at cool mode, press “ON/OFF” button to turn OFF the unit.
-
e. When the unit works at heating mode, press “ON/OFF” button, receiver receives the signal with the sound of “beep” and switch to cool mode at high speed, the indication light turns to green flicker light. The unit will continue to work in cool mode for 3 minutes and then stop. (This is to ensure the heater is been cooled down and has 3 minutes delay stop).
7.2. Controlled by the control panel in the unit is the same function as
7.1.
7.3. Overheat protection:
When the air curtain works at heating mode, there is overheat protection. When the heater temperature is overheating, heating mode will stop and switch to cool mode automatic, at the same time the indication light change to green light. When the temperature drop down to a certain temperature, if want the unit to work at heating mode, press “HEAT” button to continue to work heating mode.
8 CAUTIONS
- Turn off the interrupter or disconnect the plug for any maintenance service.
- Turn off the interrupter or disconnect the plug in case of a non product use.
- Make sure that the product provides a ground wire.
- The pictures shown on this manual are illustrative only.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
9 ATTENTION
- a)Use the unit at the rated voltage and frequency indicated on the nameplate.
- b)Do not wet the product electrical components.
- c)Never use petrol, benzene, thinners or any other such chemical to clean the unit.
- d)Routine maintenance must be done every year.
FERONO www.ferono.com info@ferono.com
WARRANTY CARD The warranty is valid only with invoice
Air curtain model . . ………………………………………..
Serial number. ……………………………………………….
Sale date . …………………………………………………….
Invoice number . . ………………………………………….
……………. Service sign and stamp
CONFIRMATION OF INSTALLATION BY AUTHORIZED SERVICE Installation date
…………………………………………….
Installation address …………………………………..
Electrical permission number. ………………………..
……………. Service sign and stamp
FERONO
www.ferono.com
info@ferono.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>