August SE 10 Portable CD and MP3 Player User Manual
- June 6, 2024
- August
Table of Contents
August SE 10 Portable CD and MP3 Player User Manual
User Manual
Thank you for purchasing August SE 1 OB Portable CD & MP3 Player. This user
manual is designed to familiarize you with all the features of this device.
Please take the time to read this user manual carefully, even if you are
already familiar with a similar product.
Safety
To ensure the safety of you and others, please read the Safety Instructions
before using this device. Please do not disassemble the SElOB, it can be
unsafe and will invalidate the manufacturer’s warranty.
Disposal
Please ensure the product and accessories are disposed of in compliance with
the WEEE (Waste Electrical and Electronic Equipment) Directive and any other
regulations applicable to your country. Always check with the environment
agency and any other relevant authorities for current disposal regulations.
Declaration of Conformity
The Declaration of Conformity can be found on our website at
http://augustint.com/en/declaration/
Customer Service
You can contact us by phone on: +44 (0)845 250 0586 or by email at:
service@augustint.com should you require
further technical support or customer service.
1. Safety Instructions
■ Storage and Use
■ Maintenance
Please unplug all leads before cleaning this device.
2. Main Features
- Stereo Speaker & 3.5mmAudio Jack
- Equaliser with 5 Sound Modes
- Adjustable Playback Speed
- Built-in Rechargeable Battery
- Anti-Skip Protection
3. Box Contents
4. Part Names and Functions
- Micro SD/TF Card
- Power ON/OFF
- DCIN5V
- Charging LED
- Earphone Port
- Decrease speed
- Increase speed
- Repeat A-B
- Programme
- Play/Pause
- Stop
- Previous
- Next
- EQ
- Mode
- OPEN
- HOLD ON/OFF
- Increase/Decrease volume
5. Operation
5.1 Power
Charging:
You can use any charger that supports USB 2.0. It will take around 4 hours to
fully charge the player. When the battery is being charged, the LED indicator
will be red. Once the player has fully charged, the LED indicator will turn
green.
Power On:
The power switch is located on the side. Please toggle it to ON. When a disc
has played to the end or there is no disc, the SE 1 OB will enter a standby
mode after 20 seconds. Please press the PLAY button again to restart the
player.
Power Off:
There are two ways to tum off the player:
- Please toggle the power switch to OFF position if the player will no longer be used for a long time;
- The player will enter a standby mode by pressing the STOP button.
Note: Please tum the power switch to OFF after use.
5.2 Music Source
CD:
Push the OPEN button to the right to open the door. Insert your index finger
into the centre hole of the disc and take the edge of the disc with your
thumb. Insert the disc upwards and press the disc gently until it clicks into
place. Close the disc door gently, otherwise the player will not read the
disc.
Note: The SE10B is only compatible with CD, CDR, MP3 & HDCD.
Micro SD/ TF Card:
Insert the Micro SD/ TF card with the arrow pointing toward the slot, and carefully slide it into the slot until it clicks into place. Turn on the player, then press and hold the Play/Pause button until ‘Sd’ displays.
Note: The SE 1 OB is compatible with MP3 format in Micro-SD Card
mode only.
5.3 Repeat
Each time the MODE button is pressed, the order of the tracks played will be as follows: Repeat Current Song Only (REPl), Repeat all (ALL), Shuffle (SHUF), Preview (INTRO) – only 10 second per track will be played in this mode.
5.4A-B Repeat
This function allows you to select a specific audio section to repeat. This is particularly useful when learning languages or instruments.
When a CD is playing, press the
To resume normal CD play, press
5.5 Programme
Press the PROG button to enter the programming mode when the play stops, press the PREVIOUS or NEXT button to select the track you want to program, press PROG again to confirm the programming.
Up to 30 tracks can be programmed in this mode. After that, press the PLAY button to enter the programming play mode. Press the STOP button directly to enter the stop mode to cancel or reprogram.
5.6 Volume
The volume dial is located on the side of the SE10B. Rotate it to the left or right to decrease or increase the volume. Please listen to music at an appropriate volume to avoid damaging your hearing.
5. 7 Equalizer
Press the EQ button to cycle through various sound modes. There are a total of 5 modes: Bass, Pop, Jazz, Rock & Classic.
5.8 Hold
After playback mode and EQ have been setup, you can toggle the Hold switch to On to prevent any settings from being changed.
5.9 Last Memory
ON: The player will play the most recently played track on the CD.
OFF: The player will not play the most recently played on the CD. Press and hold the PROG button to turn this function on or off. ON or OFF will be displayed on the screen. This function is turned on by default.
6. Troubleshooting
Problem: Cannot read disc.
7. Specification
8. Warranty
This product is guaranteed for 12 months from the date of the original purchase. In the unlikely event of any defect arising due to , faulty materials or workmanship, the unit will be either replaced or repaired free of charge (where possible) during this period. An alternative product will be offered in case the product is no longer available or repairable.
This warranty is subject to the following conditions:
■ The warranty is only valid within the country where the product is
purchased.
■ The product must be correctly installed and operated in accordance to the
instructions given in this user manual.
■ The product must be used solely for domestic purposes.
■ The warranty only covers the main unit, and does not cover the accessories.
■ The warranty does not cover the damage caused by misuse, negligence,
accident and natural disaster.
■ The warranty will be rendered invalid if the product is resold or has been
damaged by inexpert repairs. The manufactures disclaim any liability for
incidental or consequential damages.
■ Please consult our customer adviser before returning any product; we are not
responsible for any unexpected product returns.
■ Any faulty product must be kept and returned in the original packaging with
all the accessories and the original copy of the purchase receipt.
The warranty is in addition to, and does not diminish, your statutory or legal rights.
Customer Service:
Telephone: +44 (0) 845 250 0586
Email: service@augustint.com
This product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The Declaration of conformity may be consulted online at http://www.augustint.com/en/declaration
Industry Canada Statement
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (I) this device may not
cause interference, and (2) this device must accept interference, including
interference that may cause undesired operation of the device.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
No Unauthorized Modifications: Do not make any changes or modifications to this product without the prior express written approval of August International Ltd. Any changes or modifications made without express written approval could void the user’s authority to operate this product.
For details of further relevant technical standards, please contact us at the address above.
August International Ltd.
Rawmec Business Park
Hoddesdon EN11 0EE
United Kingdom
Tel: +44(0) 845 250 0586
EU Distributor:
Daffodil Germany GmbH
Bayernstr. 1 0
D-30855 Langenhagen Germany
Tel: +49 (0) 511 97812978
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>