SCHUBERTH SH HKLBI SP1 Helmet Earbud Kits Instruction Manual
- June 6, 2024
- SCHUBERTH
Table of Contents
SCHUBERTH SH HKLBI SP1 Helmet Earbud Kits Instruction Manual
SH HKLBI Installation Instructions
-
Secure helmet to prevent damage and ensure ease of installation
-
Remove the left cheek pad. The chin pad will be removed and replaced with the new one.
-
Remove the chin pad and loosely place the equipment into the helmet
-
Find the connector tether and work the clip onto the rubber seal around the bottom. It is recommended to take your time and carefully use a small screwdriver to help guide the part over the seal.
-
Carefully work the clip into place as shown. It needs to be as far back against the main EPS as possible.
-
In the same manner as in step 4 and 4.1, carefully install the earbud clip on the same side as your microphone and move into place wherever is most comfortable for the driver.
-
Install a cheek pad, then the chin pad followed by the remaining cheek pad. Don’t forget the chin straps!
-
Drop the earbud connector into the clip as shown and you’re ready to go.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>