TEGERA 777 Protective Gloves User Manual
- October 27, 2023
- 09139 AIM USB 4 Altimeter
Table of Contents
TEGERA 777 Protective Gloves
Carefully read these instructions before using this product.
DECLARATION OF CONFORMITY
EXPLANATION OF PICTOGRAMS
0 = Below the minimum performance level for the given individual hazard X= Not
submitted to the test or test method not suitable for the glove design or
material
Warning! This product is designed to provide protection specified in PPE Regulation (EU) 2016/425 with the detailed levels of performance presented below. However, always remember that no item of PPE can provide full protection and caution must always be taken when exposed to risks.
-
A. Abrasion resistance Min. 0; Max. 4
-
B. Blade cut resistance Min. 0; Max. 5
-
C. Tear resistance Min. 0; Max. 4
-
D. Puncture resistance Min. 0; Max. 4
-
E. Cut Resistance TDM Min. A; Max. F (EN ISO13997),
-
F. Impact Protection P=Pass
FITTING AND SIZING
All sizes comply with the EN 420:2003+A1:2009 for comfort, fit and dexterity,
if not explained on the front
page. If the short model symbol is shown on the front page, the glove is
shorter than a standard glove, in order to enhance the
comfort for special purposes – for example fine assembly work. Only wear the
products in a suitable size. Products which are either
too loose or too tight will restrict movement and will not provide the optimal
level of protection.
STORAGE AND TRANSPORT
Ideally stored in dry and dark condition in the original package, between +10º – +30ºC.
INSPECTION BEFORE USE : Check that the glove does not present holes, cracks, tears, colour change etc. If the product becomes damaged it will NOT provide the optimal protection and must be disposed of. Never use a damaged product.
SHELF LIFE
The nature of the materials used in this product means that the life of this product cannot be determined as it will be affected by many factors, such as storage conditions, usage etc.
CARE AND MAINTENANCE
The user bares sole responsibility for submitting the product to mechanical washing after use, as unknown substances can contaminate the product during use and may affect the performance levels of the product. To care for your product, we recommend that you rinse in cold water and line dry in room temperature.
DISPOSAL : According to local environmental legislations. ’ EN ISO 21420: The glove contains natural rubber which may cause allergy.
ALLERGENS
This product may contain components that may be a potential risk to allergic reactions. Do not use in case of hypersensitivity signs. For more information contact Ejendals.