TECNO H2 Wireless Bluetooth Headset User Manual

TECNO H2 Wireless Bluetooth Headset **Wireless Earphone

**

Model
H2 Hereby, TECNO MOBILE LIMITED. Declares that this Wireless Earphone is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU

FCC STATEMENT

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against hamful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there isno a guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the User is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help
5. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

NOTE
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equip- ment.Or Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

WELCOME
Thank you for choosing our products. The Hipods H2 wireless earphone has a fashionable design, powerful functions, and high compatibility, providing you with hands-free convenience in making calls and listening to music.

PACKAGE CONTENT

1. 2x Hipods H2 Earphones
2. 1x Charging Box
3. 1xUSB Charging Cable
4. 4x Eartips
5. 1x User Manual

SMART POP-UP CONNECTION SUPPORT MODEL (MOBILE PHONES)

1. TECNO PHANTOM 9 (Afica/ India)
2. TECNO CAMON 12 (Africa)
3. TECNO CAMON 12 Air (Africa / India /Bangladesh/Pakistan)
4. TECNO CAMON 12 Pro (Africa)
5. TECNO SPARK 4 (Africa/India/ Bangladesh/Pakistan/Oman/ Ukraine/Colombia/Qatar/ Jordan/Saudi Arabia/Thailand)

PRODUCT OVERVIEW

1. Charging indicator light
2. Micro charging port
3. Touch panel
4. Indicator light
5. Voice MIC
6. Charging contacts
7. Eartips

OPERATION AND FUNCTIONS

Power On

1. Open the charging box.
2. Long press touch panel for 3 seconds.

Power Off

1. Put earphones on the charging box.
2. Long press the touch button for 10 seconds.
3. Turn off automatically after the disconnection for 10 minutes.

Bluetooth Pairing(Phone Pairing)

1. When pairing for the first time, the Left & Right earphones will reconnect automatically and the main earphone Will enter the pairing state.
2. When Bluetooth device has been connected, the earphones will automatically reconnect when turned on. The main earphone will automatically reconnect to the last connected device. The main earphone will enter the pairing state if there is no reconnect in 10 seconds.

Connect With Phone

1. When earphones enter the pairing state, search the
2. Bluetooth pairing name and click connect.

TWS Connect

WS connects automatically after the earphones are turned on.

Use

1. Play/Pause: Double-click the touch panel to pause while playing music, and double-click to play again.
2. volume+: When playing music, press the R earphone touch panel to increase the volume.
3. Volume: When playing music, press the L earphone touch panel to reduce the volume. Previous song: When playing music, triple strike L earphone touch
4. Next song: When playing music, triple strike R earphone touch panel to switch to the next music.
5. Answer call: Double-click the touch panel while the call is coming.
6. Hang up call: Double-click the touch panel during the cal.
7. Reject call: Press the touch panel for 1 second and release after hearing the tone when the call is coming.
8. Answer the second call Double-click the touch panel during the ca.
9. Reject the second call Long press the touch panel for 1 second during the call.
10. Switch three-party call Press the touch panel for 1 second to switch during the call.
11. Reject three-party call  Double-click during the call.
12. Cal back: Click the touch panel 4 times under music pause status.
13. Start voice assistant: Press the touch panel for 4 seconds under the connected state.
14. Exit voice assistant: Long press the touch panel for4 seconds and hear the tone.
15. Clear phone pairing information: Click the touch panel 4 times in pairing mode.
16. Lost connection when over distance with phone: After the earphones lose connection with the mobile phone over a long distance, the earphones will enter into the connection state.
17. The earphones will shut down automatically if there is no connection in 3 minutes.
18. Turn off phone Bluetooth function/ disconnect actively: The earphones will enter into the pairing state.

Charging

Charging box charging operation instructions

Charging(input): Use the USB cable to charge the charging box. No wireless charging function.

Charging earphones by charging box

Put earphones in the charging box and will charge automatically.

Basic Features of Product

Indicator Light

Charging Box Indicator Light

Earphones Indicator Light

Charging Box Working Status

1. When the charging box is covered, after the earphones are fully charged, all the LED indicators of the charging box are extinguished, about 10 minutes, the charging box completely stops charging the earphones, the earphones LED indicators are off, but the earphones do not turn on automatically.
2. When the charging box is opened, after the earphones are fully charged, all the LED indicators of the charging box are extinguished, and the charging box always has a 5V output
3. When there is no earphone in the charging box, close the charging box cover, the charging LED indicator shows the current battery level and will extinguish after 5 seconds. After 1 minute, the charging box completely powers off and goes to a dormant state.
4. When there is no earphone in the charging box and the charging box is opened, the charging box always has a 5V output.

Others

1. (single or double) Earphone(s) in the charging box, the charging box is opened, and the earphones automatically power on.
2. (single or double) Earphone(s) in the charging box, the charging box is covered, and the earphones automatically power off.

WARRANTY CERTIFICATE

1. Name
2. Address
3. Telephone number
4. Date of Purchase (dd/mm/yy)
5. Store name
6. S/N

TECNO MOBILE LIMITED

TM and C2019 TECNO Corporation. All rights reserved. Other product and company names mentioned herein may be trademarks or trade names of their respective owners. Specifications are subject to change without notice. Model names and the availability of particular products may vary by region,

CAUTION

1. Risk of explosion if the battery is replaced by an incorrect type, dispose of used batteries according to the instructions.
2. The product shall only be connected to a USB interface of version USB2.0
3. The adapter shall be installed near the equipment and shall be easily accessible.
4. EUT Temperature:0 C~+45 C.

Operating Frequency

• BT: 2402-2480MHz

Modulation mode

• GFSK, T/4- DOPSK, 8DPSK (BT)
• GFSK (BLE)

Max. Of Transmit power

1. BT: 2.72dBm
2. BLE-3.97dBm

EU DECLARATION OF CONFORMTY in accordance with Annex VI of Directive 2014/53/EU of the European Parliament and of the Council

1. For the following Radio equipment:
2. Model: H2
3. Product: Wireless Earphone
4. Trade name or Brand: TECNO
5. Software/ Hardware number: 817E_v044_20/817-K5- V1.2
6. Name and address of the manufacturer or his authorised representative:
7. Manufacturer: TECNO MOBILE LIMITED
8. Add: ROOM 604 6/F SoUTH TOWER WORLD FINANCE CTR HARBOUR CITY 17 CANTON ROAD TST KL.
9. This declaration of conformity is issued under the sole responsibility of the Manufacturer.
10. The object of the declaration (identification of the radio equipment allowing traceability: it may include a colour image of sufficient clarity where necessary for the identi- fication of the radio equipment):
11. The object of the declaration described above is in co- nformity with the relevant Union harmonization legislation: Directive 2014/53/EU (RED)
12. References to the relevant harmonized standards used or references to the other technical specifications in relation to which conformity is declared:
13. Article 3.1a Health: EN 62479:2010
14. Article 3.1a Electrical Safety: EN62368-1:2014+A11:2018
15. Article 3.1b: ETSI EN 301 489-1 V2.2.3 (2019-11)
16. Draft ETSI EN 301 489-17 V3.2.2 (2019-12)
17. Article 3.2: ETSI EN 300 328 V2.2.2 (2019-07)
18. Notified Body Name: MET Laboratories, Inc.
19. Notified Body Number: 0980
20. Notified Body Assessment Performed: Module B/C on
21. Article 3.1a, 3.1b, 3.2 and 3.3
22. Technical File identification Number: N/WA
23. Where applicable, description of accessories and components, including software, which allows the radio equipment to operate as intended and covered by the EU declaration of conformity: User instructions are provided in the User Manual. The Software and Hardware versions are specified above.
24. Additional information: Referring to Article 10.2 of the Directive, this equipment is so constructed that it can be operated in all Member States, without infringing applicable requirements on the use of radio spectrum. Referring to Article 10.10 of the Directive, there are no restrictions on putting this equipment into service or of requirements for authorization of use. Please refer to the User Manual for details. On behalf of Manufacturer: TECNO MOBILE LIMITED Add: ROOM 604 6/F SoUTH TOWER WORLD FINANCE CTR HARBOUR CITY 17 CANTON ROAD TST KL (place and date of issue):
25. Shenzhen, 2019-12-25 (name, function)
26. Yiting Luo/ Manager (signature)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>