motepro Digi-Code Coding Device Instructions

June 6, 2024
motepro

motepro
Digi-Code Coding Instrucons

Both Digi-Code and Mul-Code are electronically the same.
MULTI-CODE Switches: UP for ON
DIGI-CODE Switches: DOWN for ON

  1. Open both the working original remote and the new remote to reveal two x 10 switch banks (L/H Bank = L/H Buon) on the circuit board or one bank of 10 switches for a single buon remote.
  2. Copy the switches exactly when coding Mul-Code to Mul-Code or upside down when coding Mul-Code to Digi-Code.

If no working remote is available look to the receivers on the motor/s (these are generally grey rectangular boxes aached to the motor. Remove the inspecon panels to reveal the 10 switches. This will mainly be a Mul-code receiver. Follow the steps above once you have located the switches on the receiver.

www.remotepro.com.au

WARNING

To prevent possible SERIOUS INJURY or DEATH:

  • Battery is hazardous: NEVER allow children near batteries.
  • If battery is swallowed, immediately notify a doctor.

To reduce risk of fire, explosion, or chemical burn:

  • Replace ONLY with the same size and type battery
  • DO NOT recharge, disassemble, heat above 100° C, or incinerate

Battery will cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed inside any part of the body.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals