MOTEPRO SLIM4E-V2 Genuine Remote Instructions
- June 1, 2024
- motepro
Table of Contents
MOTEPRO SLIM4E-V2 Genuine Remote
Prastel SLIME4E-V2 Instructions
Source: www.remotepro.com.au
- Press the programming button on the receiver. The LED will illuminate to indicate it is in learning mode.
- Press any button on the remote. The LED will flash while learning the new remote. When the LED stops flashing, the remote has been successfully programmed.
- Repeat Step 2 for any additional remotes within 10 seconds of learning the previous remote. Ensure the LED is on and not flashing.
- Wait 10 seconds or press the programming button on the receiver again to exit learning mode. The LED will turn off.
- Test your newly programmed remote.
WARNING!
This product may contain a coin/button cell battery. Keep product and batteries away from children. Battery can cause severe or fatal injuries in 2 hours or less if swallowed or placed inside any part of the body. Seek immediate medical attention if it is suspected that a coin/button battery has been swallowed or placed inside of any part of the body.
FAQ
What should I do if the LED does not illuminate when pressing the programming button? Check the receiver’s power supply and make sure the receiver is properly connected and functioning. How do I know if the remote has been successfully programmed? The LED on the receiver will stop flashing, indicating that the programming process is complete. What happens if I don’t press the programming button after adding new remotes? If you don’t press the programming button to exit, the receiver will automatically exit learning mode after 10 seconds. Can I program multiple remotes to the same receiver? Yes, you can program multiple remotes by repeating Step 2 for each remote within 10 seconds of programming the previous one.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>