hugolog HCD01 Smart Lock Instruction Manual
- June 6, 2024
- hugolog
Table of Contents
HCD01 Smart Lock
120mm
ITEM
SPECIFICATIONS
REMARKS
155mm
A. 1 2 3 4 5 6 7 8 9 B. 9 8 7 6 5 4 3 2 1 C. 2 2 2 2 2 2 2 2 2 D. 5 6 8 3
568391 91 5683
Forward number sequence Backward number sequence Repeat number sequence
Contain existing code sequence
SETTINGS Master code
Auto lock Silent mode Wrong code entry limit Shutdown time
FACTORY DEFAUlT
12345678 Disabled Disabled 10 times 3 minutes
Unlock the door from outside Master/User PIN Code Backup Key
Unlock the door from inside Rotate the thumbturn to vertical position
Lock the door from outside One-touch Locking Press any key on keypad for 2 sec
Enable Auto-lock When this feature is enabled, the lock will automatically
relock itself 30 sec after being unlocked.
Lock the door from inside
Rotate the thumbturn to horizontal position
IC Warning
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause
interference. (2) This device must accept any interference, including
interference that may cause undesired operation of the device. This equipment
complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body. Cet appareil est conforme aux
CNR exemptes de licence d’Industrie Canada . Son fonctionnement est soumis aux
deux conditions suivantes : ( 1 ) Ce dispositif ne peut causer d’interférences
; et ( 2 ) Ce dispositif doit accepter toute interférence , y compris les
interférences qui peuvent causer un mauvais fonctionnement de l’appareil. Ce
matériel est complété par une exposition de rayonnements FCC pour un
environnement naturel. Ce matériel doit être installé et se faire avec une
distance minimale de 20cm entre les radiateurs et les autresYour body shop.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference. (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: -Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver. -Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. -Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the
radiator & your body.
Change master code Add user code Delete user code
Enter Master mode
Enter Master mode
Enter Master mode
+ Master PIN
code + #
+ Master PIN
code + #
+ Master PIN
code + #
Silent mode
Enter Master mode
+ Master PIN
code + #
Auto lock
Enter Master mode
+ Master PIN
code + #
Vacation mode
Enter Master mode
+ Master PIN
code + #
Bluetooth
Enter Master mode
+ Master PIN
code + #
Function Extension
Enter Master mode
+ Master PIN
code + #
Wait for 2 green lights+2 beeps
Press 1
Enter new master PIN code
New master PIN code
+ #
Wait for 2 green lights+2 beeps
Press 2
Enter new master PIN code
New PIN code
+ #
Wait for 2 green lights+2 beeps
Wait for 2 green lights+2 beeps
Wait for 2 green lights+2 beeps
Wait for 2 green lights+2 beeps
Wait for 2 green lights+2 beeps
Wait for 2 green lights+2 beeps
Press 3
Press 41#
Press 42#
Press 51#
Press 52#
Press 61#
Press 62#
Press 71#
Press 72#
Press 81#
Press 82#
Enter unwanted user PIN code
Unwanted user PIN code
+ #
Enable beeper Succeed 2 green lights+2 beeps
Disable beeper Succeed 2 green lights+2 beeps
Enable auto lock Succeed 2 green lights+2 beeps
Disable auto lock Succeed 2 green lights+2 beeps
Enable vacation mode Succeed 2 green lights+2 beeps
Disable vacation mode Succeed 2 green lights+2 beeps
Enable bluetooth Succeed 2 green lights+2 beeps
Disable bluetooth Succeed 2 green lights+2 beeps
Enable network Succeed 2 green lights+2 beeps
Disable network Succeed 2 green lights+2 beeps
Wait for 2 green lights+2 beeps
Enter same PIN code
Wait for 2 green lights+2 beeps
Enter same PIN code
Succeed 2 green lights+2 beeps
New master PIN code
+ #
Succeed 2 green light+2 beeps
New PIN code
+ #
Succeed 2 green light+2 beeps
7
YNN H
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>