inventor MP862W Refrigerator Mini Bar User Manual

Inventor MP862W Refrigerator Mini Bar

SAFETY & WARNING INSTRUCTIONS

• No children under the age of 8 should be permitted to operate this electric device. Be certain, that children, handicapped people, or people with a lack of knowledge and experience, must be supervised, depending on the situation, by persons responsible for their well-being and do not undertake procedures such as the cleaning or the maintenance of this device.
•  It is important that adequate supervision is provided and no minors are left unattended
• lThis refrigerator is intended to be used in household and similar residential applications such as:
• Do not install the appliance in areas that are too humid or too cold, such as during construction
•  This device should always be kept in an upright position to avoid any damage.
•  If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons to avoid a hazard. Never attempt to dismantle, repair or modify the device.
•  Ventilation openings, in both the appliance’s enclosure and in the built-in structure should be clear of obstructions. Mechanical devices or other means of accelerated defrosting should not be used, only methods recommended from the manufacturer should be applied.
•  As this device is heavy, always be cautious when relocating, safety gloves are recommended.
•  When relocating this appliance, slightly lift from the front, in order to avoid any floor damage.
•  Do not attempt to repair, dismantle or modify this appliance. Contact your authorized service technician for repair or maintenance of this device.
•  Do not operate this unit by switching the main power supply on or off.
• During operation, do not touch the compressor or the condenser, be cautious as they are hot.
•  Do not place heavy objects on the power cord. Make sure that the cord is not compressed.
•  Do not place cord under any obstacles (carpets rugs or runners etc). Cord should be arranged away from areas where accidental tripping may occur.
•  Do not operate other electric appliances inside the food storage compartments of this device, unless recommended by the manufacturer.
•  Do not store explosive substances such us aerosol cans with a flammable propellant in this appliance.
•  The refrigerant circuit should remain intact. If damage occurs, be extremely cautious of any flames or sources of ignition. Ventilate the room.
•  Do not sit or climb on the device.
•  Do not place the unit in direct sunlight or near other heating sources like radiators, cookers, ovens or hobs.
•  Do not use the unit near heat sources, chemicals, radiators, flammable materials or fire.
• For EN standard: This appliance can be used by children aged from 8 years and above and persons with reduce physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children aged from 3 to 8 years are allowed to load and unload refrigerating appliances.
• To avoid contamination of food, please respect the following instructions:– Opening the door for long periods can cause a significant increase of the temperature in the compartments of the appliance.
• Clean regularly surfaces that can come in contact with food and accessible drainage systems.
• Clean water tanks if they have not been used for 48 h; flush the water system connected to a water supply if water has not been drawn for 5 days.（note 1）
• Store raw meat and fish in suitable containers in the refrigerator, so that it is not in contact with or drip onto other food.
• Two-star frozen-food compartments are suitable for storing pre-frozen food, storing or making ice-cream and making ice cubes.（note 2）
• One-, two- and three-star compartments are not suitable for the freezing of fresh food.（note 3）
• For appliances without a 4-star compartment: this refrigerating appliance is not suitable for freezing foodstuffs.（note 4）
• If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould from developing within the appliance.

ELECTRICAL INFORMATION

• The nameplate, with all the electrical and technical data of this appliance, is located on the rear panel.
• The appliance should be installed in accordance with national wiring regulations.
• Be sure the device is grounded properly. Proper grounding is important as it minimizes
• Ensure the wall socket is still accessible after the installation of the refrigerator.
• Do not use extension cords or adapter plugs with this device.
• Make sure not to cause damage to the electrical components (e.g. main plug, main cable, compressor). Contact the Service or an electrician to change the electrical components.
• To avoid personal injury, always disconnect the power supply of the device, before maintenance.

 SOCIABLE REMARKS ON ENVIRONMENTAL PROTECTION

• This appliance requires special treatment for disposal. In the European Union, electronic equipment must not be treated as domestic waste, but must be disposed of professionally in accordance with Directive 2002/96/EC of the European Parliament and Council of 27th January 2003 concerning old electrical and electronic equipment. The disposal of this unit should follow all legal requirements and should not be disposed as unsorted municipal waste.
• The hazardous substances can leak into the ground water supply thus entering the food chain, endangering your health and the environment.
• There are several alternative solutions for disposal. Please remove all doors before disposal to prevent children’s accidental trapping.
  •  Your local municipality has established free collection systems for electronic waste.
  •  Your local retailer upon purchase of a new product.
  •  The manufacturer may accept the old appliance for disposal.
  •  Old appliances sometimes contain valuable resources for scrap metal dealers.

STEPS BEFORE USE

Please refer to the electronic warranty instructions, in the last page (English section) of this manual.

For warranty purposes, please note the SN (serial number). The SN is labeled opposite the device.

5ETTING TO KNOW YOUR MINI BAR

1.  Thermostat
2. Defrosting Pan
3. Interior Light
4. Shelf
5.  Bucket
6. Door Compartments .
7. Bottle Rack
8. Reversible Door
9. Adjustable Foot
10. Power Cord

 MINI BAR FEATURES

Place the appliance in a location where the ambient temperature corresponds to the ambient temperature:

Interior Dimensions (mm)

 INSTALLATION GUIDELINES

Position

Upon the positioning of this unit. keep in mind the floor must be flat and sturdy and theroom should be well ventilated, without additional heating sources nearby.

1. Allow sufficient air ventilation surrounding the unit. The rear end (backside) of this appliance should stand against a wall allowing follows:10cm from the top 10cm from the back 10cm from the rest sides
2.  Wait at least 4 hours before connecting the appliance to the power supply, thus, allowing alfluids to settle In the compressor.
3.  Upon initial use, operate continuously for 24 hours, thus ensuring the correct temperature is reached and smooth operation of the unit is achieved.

Reversible Door
The door opening can change from either the left or the right side, according to what is best suited for its location. Ensure there is enough adequate space for the door toopen fully. Tohange the door opening direction, please follow the mentioned below instructions:

1.  Adjust the leveling foot to its highest position. Tilt the unit slightly backwards to take so that it will not slip during the door reversing process.
2.  Remove the plastic cover located on the top right or left (depending on initial door installation side) of the door hinge, and unscrew the two screws with the stabilizing pin.
3. Slightly tilt so that you may have access to the front bottom bracket. Unscrew the two screws located on the bottom left or right (depending on initial door installation side)and remove the foot from the opposite side. Once top and bottom screws and also the opposite foot are removed, the door will be completely released.
4. Remove the three plastic caps from the side you are going to install the door, and place them on the side where the door was originally installed, in order to cover the three screw holes.
5.  Place the door on the desired side making sure it is in its upright position. Screw the top two screws of the door hinge. Slightly tilt, for better positioning, and screw the bottom hinge into place, and also screw the removed foot on the other side.
6. Once completed clip on the top plastic cap.
7. Check if door is aligned horizontally and vertically and that the door when shut is completely sealed from all sides.
8. Finally tighten the bottom hinge and re-adjust the foot on the opposite side for correct leveling.

Leveling the Unit
Adjust the levelling foot at the front of the unit. If the unit is not aligned, the door and magnetic seal alignments will not be covered properly .

SETTINGS

Thermorstat Temperature Setting The thermostat is located in the interior at the upper part of the refrigerator. The thermostat setting levels are the following:

• Setting “OFF”: the cooling operation stops
• Setting “MIN”: Minimum cooling It is suggested when the storage quantity is very small.
• Setting “MED”: Normal coolingbe sure to set the thermostat to the MED setting and wait 24hours before placing items inside.
• Setting “MAX”: Maximum cooling If there is a large amount of frozen goods, or if the outside temperature is high, the thermostat knob may be set to its highest position, for a short time.

MAINTENANCE & CLEANING

• Prior to cleaning the appliance, un-plug from the wall power socket, and remove all shelves.
• Clean the appliance with a moist soft cloth. Use only neutral detergents.
• Clean the unit’s interior with a weak bicarbonate soda solution and rinse with warm water applying a damp sponge or cloth.
• Use a damp cloth to clean the exterior, keep in mind the door must be shut to avoid getting any polish on the magnetic door seal or the interior of the unit.
• Upon cleaning, rinse the interior with clean water and dry.
• Allow the appliance to dry for approximately 1 to 2 hours.
• Set thermostat to middle position. Plug into a power source. The appliance will chill continuously until set temperature has been reached.
• Frequently the air vents and the condenser must be cleaned located at the rear end of the appliance, using a vacuum cleaner or a brush. The condenser should always be clean,

Defrosting

It is recommended to defrost the chill box when 3-4mm frost has been accumulated. To implement the defrosting process, consider the following steps:

1.  Unplug the appliance.
2.  Empty the appliance.
3.  Keep the door open while the defrosting process is on progress.
4.  Make sure that the interior is free of frost and clean the chill box with a soft cloth.

Interior Light
Thanks to the interior lighting you can have a better insight of your products storage. In the event of a malfunction, you can change the interior light bulb of the refrigerator by yourself, following the below steps:

• pull the plug from the socket
• remove the cover from the lighting
• check if the bulb is fully screwed in
• replace it with a bulb of the same type
• replace the cover
• put the plug into the socket

STORAGE

When appliance is inactive for an extended period of time, please make sure you follow the instructions below, for the appropriate storage of your appliance: Remove all the items from the interior compartment.

• Clean the removable parts of the device.
• Leave the door open to prevent unpleasant odors.
• Cover the device.
•  Store the refrigerator in upright position, in a dry, well ventilated area and avoid direct sunlight.

TIPS

• Do not place products too close. Ensure a sufficient distance for optimum air circulation
• Avoid extensive use of the door on wet and hot weather, keep in mind, once the door is opened to shut the soonest possible.
• Be certain the wall behind the appliance is dirt and dust free, especially with outer condenser-equipped units. Do
• It is the most energy-efficient to place food in the position shown in the picture above. not place goods that are not sealed or well packed directly under the chill box.
• Do not place goods in direct contact with the wall of the refrigerator, always allow some space.Suggested storage time 3days to 5days.

TROUBLESHOOTING

Dear customer

1.  If you want to return O「replace the product, please contact the store where you buy. (Remember to bring the purchase invoice)
2.  If your product breaks down which needs to repair, please contact after-sales service provider.

Activate your Warranty

• Visit our web site and activate your warranty via the below link or by
  scanning the QR code https://www.inventorappliances.com/warranty-card

• Fill all the fields as shown below

References

• Inventor

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>