FERM SGM1006 Gas Soldering Iron Instruction Manual
- June 5, 2024
- FERM
Table of Contents
FERM SGM1006 Gas Soldering Iron Instruction Manual
Features
- Switch
- Nut
- Soldering head
- Filling valve
- low control knob
- Ignition button
- Guard
- Standard tip
- Diagonal tip (3 mm)
- Chisel tip (3,5 mm)
- Hot knife
- Hot blower
- Reflector
- Wrench (7 mm)
- Wrench (8 mm)
Warnings
- Do not fill gas or store near open flame, heater or combustible materials
- Use only high quality butane gas
- Butane gas is highly flammable, please handle with care
- Do not drop, puncture, or incinerate
- Do not store or operate in a place where the temperature is above 50º C (122º F)
- Keep out of reach of children
- Cool down before putting protective cap on and before storing.
Gas filling and refilling
- Ensure the switch (1) is turned to the OFF position before filling
- Reverse the unit; insert the gas container’s nozzle vertically into filling valve (5)
- When gas escapes from filling valve, remove the nozzle from the filling valve
Ignition
- Move the flow control knob (6) to the middle position
- Move the switch (1) upward and to the right
- Press down the ignition button (7) to light up the open flame
Shutting off
Move the switch (1) upwards and to the left. The switch will return to OFF position.
Flame lengt or temperature adjustment
After ignition, turn the flow control knob (6) to the right to increase the flame length of the torch or the temperature of soldering tip or hot air, to the left to decrease the flame length or the temperature.
Operating tips
- After filling or refilling with gas, wait for approximately 2 minutes so that the gas in the cylinder can be stable.
- Soldering tips must be tin-plated before using them for the first time. A thin layer of solder should be applied to the tip when it has been heated.
- Soldering should NOT be carried out on “live” circuits, as this soldering unit does notpossess any special electrical insulation
- Keep your soldering sponge moist
How to fit or replace different accessoires
Always allow unit to cool before removing or replacing tips
Replace soldering tips
- With 7 mm wrench (15) on the soldering tip or hot blow head (9 till 14) and 8 mm wrench on the soldering head (4), you can tight the tip or hot blow head or unscrew them.
- When you unscrew the nut (3), you can remove the guard (8) and soldering head (4). Now the unit becomes an open flame torch.
Troubleshooting
Does not ignite
- Empty gas
- Refill butane gas
- Gas pressure too high or too low
- Slide flow control knob (6) to lower or higher position
Torch flame has no proper power
- Insufficient gas power
- Refill butane gas
Tip does not heat
- Insufficient gas power
- butane gas
Warranty
The warranty conditions can be found on the separately enclosed warranty card.
DECLARATION OF CONFORMITY
SGM1006 SOLDERING GUN / BLOW TORCH
We declare under our sole responsibility that this product is in conformity and accordance with the following standards and regulations:
DIN EN521, DIN EN731
2006/42/EC, PVGW VP 103 DIN 30665-1
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>