ferm E27 Dae Floor Lamp Instruction Manual
- June 1, 2024
- FERM
Table of Contents
ferm E27 Dae Floor Lamp
Specifications
- Product Name: Dae Floor Lamp
- Power Supply: 220V-240VAC, 60Hz
- Certifications : CE, RoHS, UKCA, CB
- Protection Rating: IP20
- Socket Type: E27
- Bulb Capacity : 3pcs max 10W LED
Product Usage Instructions
Unboxing and Initial Setup
Pull the floor lamp out of the box by holding the top and bottom cardboard protections. Avoid touching the lampshade surface.
Assembly
- Loosen the three finger screws and remove the cardboard tray.
- Dismantle the base and inner structure with care.
- Mount an E27 LED light bulb in each socket.
- Carefully align and tighten the base and inner structure using the finger screws.
Final Adjustments
Turn the lampshade by holding it at the bottom and top. Adjust the lamp base by manipulating the feet if needed.
FAQ
- Q: Can I use any type of light bulb with the Dae Floor Lamp?
- A: To protect the shade, only use LED light bulbs with a maximum of 10W in each socket.
- Q: How should I handle the lamp during installation?
- A: When moving or assembling the lamp, avoid pressing the surface of the lampshade with your hands. Manipulate the lamp by holding it from the top or bottom.
General Instructions
PLEASE READ BEFORE INSTALLATION
WARNING:
The safety of this product can only be guaranteed if the following
instructions are observed during both installation and use. Please retain
these instructions safely after installation.
CAUTION
- Do not press the surface with your hands when moving the lamp base.
PLEASE OBSERVE THE FOLLOWING GUIDELINES
- Ensure that the power supply has been switched off prior to installation or removal of the product.
- Never undertake an electrical installation without the proper knowledge or training. If not familiar with electrical wiring, contact a qualified electrician.
- The product may in no way be modified or tampered with. Any modification may compromise safety and make the product itself dangerous to use. FERM LIVING does not accept any responsibility for products that have been modified.
- This product requires the use of a lightbulb that is not included. Please use a lightbulb that has the relevant safety certifications and approvals for your area.
- Any modification must be performed only by qualified personnel to avoid any danger.
- This product is meant for indoor use only.
- This appliance should not be disposed in a domestic trash receptacle and should instead be recycled appropriately.
CLEANING INSTRUCTIONS
- Use only a soft cloth to clean the product.
MORE INFORMATION
To access further information such as product overview and material descriptions, please visit our website at www.fermliving.com. If you have any questions or comments, please do not hesitate to contact us at info@fermliving.com.
Technical Specifications
DAE FLOOR LAMP
- Voltage: 220V-240VAC, 60Hz
- Dimmable: No
- Certification: CE, RoHS, UKCA, CB, IP20
- Socket: E27 socket base
- Light source: 3pcs Bulb max 10W LED To protect the shade, only use LED light bulb. (Light bulb not included)
Assembly Process
- Pull the floor lamp out of the box by holding the top cardboard protection and bottom cardboard protection. Do not touch the surface of the lampshade.
- When the lamp is upside down, make sure to only manipulate the lamp by its top or bottom. Do not press or hold on the lampshade.
- Dismantle the base and inner structure with care.
Mount a light bulb, E27 in each socket.(Light bulb not included).
- Carefully mount the base and inner structure by aligning with the positioning rod. Tighten the three finger screws.
- Carefully turn the lampshade by holding at the bottom and top. Adjust the lamp base by adjusting the feet if necessary.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>