bomaker 495959 100-Inch Projector Screen User Manual

June 5, 2024
bomaker

bomaker 495959 100-Inch Projector Screen

bomaker 495959 100-Inch
Projector Screen fig 1

Package Listing

bomaker 495959 100-Inch Projector Screen fig
2

Product description

bomaker 495959 100-Inch Projector Screen fig
3

CIRCUIT DIAGRAMS

If the motorized screen work with manual switch, please refer to the below fig for electric connection.bomaker 495959 100-Inch Projector Screen fig
4

If the motorized screen work with remote control, please refer to the below fig for electric connection. bomaker 495959 100-Inch Projector Screen fig
5

If the remote control does not work well, please check the battery and replace new one.

ADJUST LIMIT SWITCH

Adjust the position for the two limited journey, refer to below picture:bomaker 495959 100-Inch Projector Screen fig 6

 Product Parameters

Over Size: 67.60inch H X 98.54inch W View Size: 49.02inch H X 87.17inch W l00inch( Aspect Ratio: 16:9) bomaker 495959 100-Inch Projector Screen fig
7bomaker 495959 100-Inch Projector Screen fig
8

All dimensions are measured manually with deviation ranged at ±l.18inch, please refer to the real object.

Installation

Ceiling Installation:
Drill a hole on the wall, then put the expansion rubber sleeve and the hook screw into the hole one after another, and then tighten the screw.

Wall Installation

Wooden wall:
If it was the wooden wall, first drive the screw nails into the wall and fix the screw nails in the holes of the Motorized Screen.

Bricks/Precast Concrete Wall:
If it is a brick or concrete wall, you need to drill holes on the wall first, put in the expansion rubber sleeve and then screw in the nail, and then hang the screen via the small holes on the motorized screen.bomaker 495959
100-Inch Projector Screen fig 10

Note: The screen can be installed on the wooden/concrete foundation /brick wall Remote Control Instruction:
The Motorized Screen has two use methods: control the power switch manually and control the power switch via the remote. (1) Lift and lower the screen via control the power switch manually

  1. Unfold the screen: press the lower end of the power switch, the screen will move down slowly automatically, and the screen will automatically stop when the screen is opened to the maximum.
  2. Retract the screen: press the upper end of the power switch, the screen will be rolled back into the metal housing and stop automatically.
  3. Stop the screen: press the middle of the power switch, and the screen will stop at any position you want.

Note: It is recommended to place the control switch in the middle position when the screen is not in use.
(2) Control the screen via remote Point the remote transmitter at the direction of the receiver box, and press the upper/lower/middle button of the remote to control the screen up, down and stop respectively.

Care & Warnings

  • Bowmaker highly recommends two people to assemble the Motorized Screen.
  • Dust, dirt, and scratches on the projection surface will affect the picture quality. Please note the below points:
  1. Do not touch the projection surface with your hands.
  2. Do not write or draw on the projection surface.
  3. Do not use fingers or sharp objects to point on the projection surface, which will cause damage to the screen material.
  4. Use a soft-damp cloth to clean the projection surface; do not use chemical cleaning agents or alcohol.
  5. Use clean water when dampening the cleaning cloth and do not rub against the material to clean it.
  6. After using put the screen back to the housing in order to avoid being polluted. If not using it for a long time, please take the screen from the wall and pack it in a carton.
  7. Frequently examine the installation for imbalance and signs of wear or damage to cables and springs.
  8. If the power soft cable was broken, you have to replace it by technical people from the manufacturer or service department ensure safety.
  9. Do not use if repair or adjustment is necessary;
  10. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
  11. Do not use if repair or adjustment is necessary.
    NOTE: To avoid damage and injury, the screen should only be operated by adults.

support@bomaker.com

www.bomaker.com

@BomakerOffcial

+ 1(437)800-0151

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals